X-Git-Url: https://git.librecmc.org/?a=blobdiff_plain;f=include%2Fconfigs%2Fv38b.h;h=0f8d5a91574036a689c18f296533732d646be637;hb=7fd0bea2e4a78eab7e6693140940f9f9a0009bc2;hp=554a7a41b8e60516e88c92132c9541631184fb18;hpb=d3bb5ec198edad4869ac5276a5899881b7bf5433;p=oweals%2Fu-boot.git

diff --git a/include/configs/v38b.h b/include/configs/v38b.h
index 554a7a41b8..0f8d5a9157 100644
--- a/include/configs/v38b.h
+++ b/include/configs/v38b.h
@@ -39,16 +39,14 @@
 #define CONFIG_NETCONSOLE		1
 
 #define CONFIG_BOARD_EARLY_INIT_R	1	/* do board-specific init */
+#define CONFIG_BOARD_EARLY_INIT_F	1	/* do board-specific init */
 
 #define CFG_XLB_PIPELINING		1	/* gives better performance */
 
 #define BOOTFLAG_COLD		0x01	/* Normal Power-On: Boot from FLASH  */
 #define BOOTFLAG_WARM		0x02	/* Software reboot */
 
-#define CFG_CACHELINE_SIZE	32	/* For MPC5xxx CPUs */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
-#  define CFG_CACHELINE_SHIFT	5	/* log base 2 of the above value */
-#endif
+#define CONFIG_HIGH_BATS	1	/* High BATs supported */
 
 /*
  * Serial console configuration
@@ -88,28 +86,37 @@
 #define CONFIG_USB_CLOCK	0x0001BBBB
 #define CONFIG_USB_CONFIG	0x00001000
 
+
 /*
- * Supported commands
+ * BOOTP options
  */
-#define CONFIG_COMMANDS		(CONFIG_CMD_DFL	| \
-				 CFG_CMD_FAT	| \
-				 CFG_CMD_I2C	| \
-				 CFG_CMD_IDE	| \
-				 CFG_CMD_PING	| \
-				 CFG_CMD_DHCP	| \
-				 CFG_CMD_DIAG	| \
-				 CFG_CMD_IRQ	| \
-				 CFG_CMD_JFFS2	| \
-				 CFG_CMD_MII	| \
-				 CFG_CMD_SDRAMi	| \
-				 CFG_CMD_DATE	| \
-				 CFG_CMD_USB	| \
-				 CFG_CMD_FAT)
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
+
+#define CONFIG_CMD_FAT
+#define CONFIG_CMD_I2C
+#define CONFIG_CMD_IDE
+#define CONFIG_CMD_PING
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_DIAG
+#define CONFIG_CMD_IRQ
+#define CONFIG_CMD_JFFS2
+#define CONFIG_CMD_MII
+#define CONFIG_CMD_SDRAM
+#define CONFIG_CMD_DATE
+#define CONFIG_CMD_USB
+#define CONFIG_CMD_FAT
 
-#define CONFIG_TIMESTAMP		/* Print image info with timestamp */
 
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
+#define CONFIG_TIMESTAMP		/* Print image info with timestamp */
 
 /*
  * Boot low with 16 MB Flash
@@ -123,7 +130,7 @@
 #define CONFIG_BOOTDELAY	3	/* autoboot after 3 seconds */
 
 #define CONFIG_PREBOOT	"echo;"	\
-	"echo Type \"run flash_nfs\" to mount root filesystem over NFS;" \
+	"echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;" \
 	"echo"
 
 #undef CONFIG_BOOTARGS
@@ -135,7 +142,7 @@
 	"preboot=echo;echo Type \"run flash_nfs\" to mount root "	\
 		"filesystem over NFS; echo\0"				\
 	"netdev=eth0\0"							\
-	"ramargs=setenv bootargs root=/dev/ram rw\0"			\
+	"ramargs=setenv bootargs root=/dev/ram rw wdt=off \0"		\
 	"addip=setenv bootargs $(bootargs) "				\
 		"ip=$(ipaddr):$(serverip):$(gatewayip):"		\
 		"$(netmask):$(hostname):$(netdev):off panic=1\0"	\
@@ -144,7 +151,7 @@
 		"$(ramdisk_addr)\0"					\
 	"net_nfs=tftp 200000 $(bootfile);run nfsargs addip;bootm\0"	\
 	"nfsargs=setenv bootargs root=/dev/nfs rw "			\
-		"nfsroot=$(serverip):$(rootpath)\0"			\
+		"nfsroot=$(serverip):$(rootpath) wdt=off\0"		\
 	"hostname=v38b\0"						\
 	"ethact=FEC ETHERNET\0"						\
 	"rootpath=/opt/eldk-3.1.1/ppc_6xx\0"				\
@@ -166,7 +173,7 @@
 /*
  * IPB Bus clocking configuration.
  */
-#undef CFG_IPBSPEED_133			/* define for 133MHz speed */
+#undef CFG_IPBCLK_EQUALS_XLBCLK			/* define for 133MHz speed */
 #endif
 
 /*
@@ -194,7 +201,7 @@
  * Flash configuration - use CFI driver
  */
 #define CFG_FLASH_CFI		1		/* Flash is CFI conformant */
-#define CFG_FLASH_CFI_DRIVER	1		/* Use the common driver */
+#define CONFIG_FLASH_CFI_DRIVER	1		/* Use the common driver */
 #define CFG_FLASH_CFI_AMD_RESET	1
 #define CFG_FLASH_BASE		0xFF000000
 #define CFG_MAX_FLASH_BANKS	1		/* max num of flash banks */
@@ -206,10 +213,10 @@
 /*
  * Environment settings
  */
-#define CFG_ENV_IS_IN_FLASH	1
-#define CFG_ENV_ADDR		(CFG_FLASH_BASE + 0x00040000)
-#define CFG_ENV_SIZE		0x10000
-#define CFG_ENV_SECT_SIZE	0x10000
+#define CONFIG_ENV_IS_IN_FLASH	1
+#define CONFIG_ENV_ADDR		(CFG_FLASH_BASE + 0x00040000)
+#define CONFIG_ENV_SIZE		0x10000
+#define CONFIG_ENV_SECT_SIZE	0x10000
 #define CONFIG_ENV_OVERWRITE	1
 
 /*
@@ -253,7 +260,7 @@
  */
 #define CFG_LONGHELP			/* undef to save memory */
 #define CFG_PROMPT		"=> "	/* Monitor Command Prompt */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
 #define CFG_CBSIZE		1024	/* Console I/O Buffer Size */
 #else
 #define CFG_CBSIZE		256	/* Console I/O Buffer Size */
@@ -269,6 +276,11 @@
 
 #define CFG_HZ			1000	/* decrementer freq: 1 ms ticks */
 
+#define CFG_CACHELINE_SIZE	32	/* For MPC5xxx CPUs */
+#if defined(CONFIG_CMD_KGDB)
+#  define CFG_CACHELINE_SHIFT	5	/* log base 2 of the above value */
+#endif
+
 /*
  * Various low-level settings
  */