X-Git-Url: https://git.librecmc.org/?a=blobdiff_plain;f=include%2Fconfigs%2FTQM834x.h;h=a79dabef61313073493fde7cba0005f4bf0755e8;hb=711391131c84398d1b8256ab5a8cfa2969ad57c7;hp=7b496c853f3b3c9184a1f7412b42312d49e712a3;hpb=d283a5709d8e2bf2682a2e22fb81a47b8d53c111;p=oweals%2Fu-boot.git

diff --git a/include/configs/TQM834x.h b/include/configs/TQM834x.h
index 7b496c853f..a79dabef61 100644
--- a/include/configs/TQM834x.h
+++ b/include/configs/TQM834x.h
@@ -12,9 +12,6 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
-#define CONFIG_SYS_GENERIC_BOARD
-#define CONFIG_DISPLAY_BOARDINFO
-
 /*
  * High Level Configuration Options
  */
@@ -44,7 +41,6 @@
 #define CONFIG_SYS_LCRR_CLKDIV	LCRR_CLKDIV_8
 
 /* board pre init: do not call, nothing to do */
-#undef CONFIG_BOARD_EARLY_INIT_F
 
 /* detect the number of flash banks */
 #define CONFIG_BOARD_EARLY_INIT_R
@@ -159,7 +155,6 @@
  * Serial Port
  */
 #define CONFIG_CONS_INDEX	1
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE	1
 #define CONFIG_SYS_NS16550_CLK		get_bus_freq(0)
@@ -184,19 +179,11 @@
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN		2	/* 16 bit */
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS	5	/* 32 bytes/write */
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS	12	/* 10ms +/- 20% */
-#define CONFIG_SYS_I2C_MULTI_EEPROMS		/* more than one eeprom */
 
 /* I2C RTC */
 #define CONFIG_RTC_DS1337			/* use ds1337 rtc via i2c */
 #define CONFIG_SYS_I2C_RTC_ADDR		0x68	/* at address 0x68 */
 
-/* I2C SYSMON (LM75) */
-#define CONFIG_DTT_LM75			1	/* ON Semi's LM75 */
-#define CONFIG_DTT_SENSORS		{0}	/* Sensor addresses */
-#define CONFIG_SYS_DTT_MAX_TEMP		70
-#define CONFIG_SYS_DTT_LOW_TEMP		-30
-#define CONFIG_SYS_DTT_HYSTERESIS	3
-
 /*
  * TSEC
  */
@@ -230,11 +217,9 @@
  * General PCI
  * Addresses are mapped 1-1.
  */
-#define CONFIG_PCI
 
 #if defined(CONFIG_PCI)
 
-#define CONFIG_PCI_PNP			/* do pci plug-and-play */
 #define CONFIG_PCI_SCAN_SHOW		/* show pci devices on startup */
 
 /* PCI1 host bridge */
@@ -285,34 +270,15 @@
 #define CONFIG_BOOTP_GATEWAY
 #define CONFIG_BOOTP_HOSTNAME
 
-
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
-#define CONFIG_CMD_ASKENV
-#define CONFIG_CMD_DATE
-#define CONFIG_CMD_DHCP
-#define CONFIG_CMD_DTT
-#define CONFIG_CMD_EEPROM
-#define CONFIG_CMD_I2C
-#define CONFIG_CMD_NFS
-#define CONFIG_CMD_JFFS2
-#define CONFIG_CMD_MII
-#define CONFIG_CMD_PING
 #define CONFIG_CMD_REGINFO
-#define CONFIG_CMD_SNTP
 
 #if defined(CONFIG_PCI)
     #define CONFIG_CMD_PCI
 #endif
 
-#if defined(CONFIG_SYS_RAMBOOT)
-    #undef CONFIG_CMD_SAVEENV
-    #undef CONFIG_CMD_LOADS
-#endif
-
 /*
  * Miscellaneous configurable options
  */
@@ -322,8 +288,6 @@
 #define CONFIG_CMDLINE_EDITING	1	/* add command line history */
 #define CONFIG_AUTO_COMPLETE		/* add autocompletion support */
 
-#define CONFIG_SYS_HUSH_PARSER		1	/* Use the HUSH parser */
-
 #if defined(CONFIG_CMD_KGDB)
 	#define CONFIG_SYS_CBSIZE	1024	/* Console I/O Buffer Size */
 #else
@@ -338,11 +302,6 @@
 
 #undef CONFIG_WATCHDOG		/* watchdog disabled */
 
-/* pass open firmware flat tree */
-#define CONFIG_OF_LIBFDT	1
-#define CONFIG_OF_BOARD_SETUP	1
-#define CONFIG_OF_STDOUT_VIA_ALIAS	1
-
 /*
  * For booting Linux, the board info and command line data
  * have to be in the first 256 MB of memory, since this is
@@ -506,11 +465,8 @@
 				/* default location for tftp and bootm */
 #define CONFIG_LOADADDR		400000
 
-#define CONFIG_BOOTDELAY	6	/* -1 disables auto-boot */
 #undef  CONFIG_BOOTARGS		/* the boot command will set bootargs */
 
-#define CONFIG_BAUDRATE		115200
-
 #define CONFIG_PREBOOT	"echo;"	\
 	"echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;" \
 	"echo"