X-Git-Url: https://git.librecmc.org/?a=blobdiff_plain;f=include%2Fconfigs%2FDP405.h;h=acc2bd2639ebefc1ba408e24e4ec855d4f24b4e0;hb=df4a0796e86662536df2387ddcf969c2a704bcc2;hp=666a0d0ff836549e6c6480aab02c11f302cee239;hpb=c837dcb1a316745092567bfe4fb266d0941884ff;p=oweals%2Fu-boot.git

diff --git a/include/configs/DP405.h b/include/configs/DP405.h
index 666a0d0ff8..acc2bd2639 100644
--- a/include/configs/DP405.h
+++ b/include/configs/DP405.h
@@ -40,39 +40,44 @@
 #define CONFIG_BOARD_EARLY_INIT_F 1	/* call board_early_init_f()	*/
 #define CONFIG_MISC_INIT_R	1	/* call misc_init_r()		*/
 
-#define CONFIG_SYS_CLK_FREQ	33333334 /* external frequency to pll	*/
+#define CONFIG_SYS_CLK_FREQ	33333300 /* external frequency to pll	*/
 
 #define CONFIG_BAUDRATE		9600
 #define CONFIG_BOOTDELAY	3	/* autoboot after 3 seconds	*/
 
 #undef	CONFIG_BOOTARGS
-#define CONFIG_RAMBOOTCOMMAND							\
-	"setenv bootargs root=/dev/ram rw nfsroot=$(serverip):$(rootpath) "	\
-	"ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):$(hostname)::off;"	\
-	"bootm ffc00000 ffca0000"
-#define CONFIG_NFSBOOTCOMMAND							\
-	"setenv bootargs root=/dev/nfs rw nfsroot=$(serverip):$(rootpath) "	\
-	"ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):$(hostname)::off;"	\
-	"bootm ffc00000"
-#define CONFIG_BOOTCOMMAND CONFIG_RAMBOOTCOMMAND
-
-#define CONFIG_LOADS_ECHO	1	/* echo on for serial download	*/
+#undef  CONFIG_BOOTCOMMAND
+
+#define CONFIG_PREBOOT                  /* enable preboot variable      */
+
 #define CFG_LOADS_BAUD_CHANGE	1	/* allow baudrate change	*/
 
 #define CONFIG_MII		1	/* MII PHY management		*/
 #define CONFIG_PHY_ADDR		0	/* PHY address			*/
 
-#define CONFIG_COMMANDS	      ( CONFIG_CMD_DFL	| \
-				CFG_CMD_BSP	| \
-				CFG_CMD_DHCP	| \
-				CFG_CMD_IRQ	| \
-				CFG_CMD_ELF	| \
-				CFG_CMD_DATE	| \
-				CFG_CMD_I2C	| \
-				CFG_CMD_EEPROM	)
 
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
+
+#define CONFIG_CMD_BSP
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_IRQ
+#define CONFIG_CMD_ELF
+#define CONFIG_CMD_DATE
+#define CONFIG_CMD_I2C
+#define CONFIG_CMD_EEPROM
+
 
 #undef	CONFIG_WATCHDOG			/* watchdog disabled		*/
 
@@ -81,6 +86,8 @@
 
 #define CONFIG_SDRAM_BANK0	1	/* init onboard SDRAM bank 0	*/
 
+#define CONFIG_PRAM		2	/* reserve 2 kB "protected RAM" */
+
 /*
  * Miscellaneous configurable options
  */
@@ -92,7 +99,7 @@
 #define CFG_PROMPT_HUSH_PS2	"> "
 #endif
 
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
 #define CFG_CBSIZE	1024		/* Console I/O Buffer Size	*/
 #else
 #define CFG_CBSIZE	256		/* Console I/O Buffer Size	*/
@@ -209,9 +216,9 @@
 /*-----------------------------------------------------------------------
  * Environment Variable setup
  */
-#define CFG_ENV_IS_IN_EEPROM	1	/* use EEPROM for environment vars */
-#define CFG_ENV_OFFSET		0x100	/* environment starts at the beginning of the EEPROM */
-#define CFG_ENV_SIZE		0x700	/* 2048 bytes may be used for env vars*/
+#define CONFIG_ENV_IS_IN_EEPROM	1	/* use EEPROM for environment vars */
+#define CONFIG_ENV_OFFSET		0x100	/* environment starts at the beginning of the EEPROM */
+#define CONFIG_ENV_SIZE		0x700	/* 2048 bytes may be used for env vars*/
 				   /* total size of a CAT24WC16 is 2048 bytes */
 
 #define CFG_NVRAM_BASE_ADDR	0xF0000500		/* NVRAM base address	*/
@@ -234,16 +241,6 @@
 #define CFG_EEPROM_PAGE_WRITE_DELAY_MS	10   /* and takes up to 10 msec */
 #define CFG_EEPROM_PAGE_WRITE_ENABLE
 
-/*-----------------------------------------------------------------------
- * Cache Configuration
- */
-#define CFG_DCACHE_SIZE		16384	/* For IBM 405 CPUs, older 405 ppc's	*/
-					/* have only 8kB, 16kB is save here	*/
-#define CFG_CACHELINE_SIZE	32	/* ...			*/
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
-#define CFG_CACHELINE_SHIFT	5	/* log base 2 of the above value	*/
-#endif
-
 /*-----------------------------------------------------------------------
  * External Bus Controller (EBC) Setup
  */