X-Git-Url: https://git.librecmc.org/?a=blobdiff_plain;f=README;h=1ea397a35cadd7efcb7008e815ea13074320794c;hb=3b1f681131149b5f62602f582a7e60b0185a2a49;hp=a70af9864676652bd127fc1cdb1dfc7739472e96;hpb=08442ec7633c69c882a4a6bd70831226d7a81556;p=oweals%2Fu-boot.git

diff --git a/README b/README
index a70af98646..1ea397a35c 100644
--- a/README
+++ b/README
@@ -1873,12 +1873,6 @@ CBFS (Coreboot Filesystem) support
 		boot.  See the documentation file README.video for a
 		description of this variable.
 
-		CONFIG_VIDEO_VGA
-
-		Enable the VGA video / BIOS for x86. The alternative if you
-		are using coreboot is to use the coreboot frame buffer
-		driver.
-
 
 - Keyboard Support:
 		CONFIG_KEYBOARD
@@ -3096,17 +3090,6 @@ CBFS (Coreboot Filesystem) support
 		memories can be connected with a given cs line.
 		Currently Xilinx Zynq qspi supports these type of connections.
 
-		CONFIG_SYS_SPI_ST_ENABLE_WP_PIN
-		enable the W#/Vpp signal to disable writing to the status
-		register on ST MICRON flashes like the N25Q128.
-		The status register write enable/disable bit, combined with
-		the W#/VPP signal provides hardware data protection for the
-		device as follows: When the enable/disable bit is set to 1,
-		and the W#/VPP signal is driven LOW, the status register
-		nonvolatile bits become read-only and the WRITE STATUS REGISTER
-		operation will not execute. The only way to exit this
-		hardware-protected mode is to drive W#/VPP HIGH.
-
 - SystemACE Support:
 		CONFIG_SYSTEMACE
 
@@ -5490,7 +5473,7 @@ loaded to, and "Flash Location" gives the image's address in NOR
 flash or offset in NAND flash.
 
 *Note* - these variables don't have to be defined for all boards, some
-boards currenlty use other variables for these purposes, and some
+boards currently use other variables for these purposes, and some
 boards use these variables for other purposes.
 
 Image		    File Name	     RAM Address       Flash Location