X-Git-Url: https://git.librecmc.org/?a=blobdiff_plain;ds=sidebyside;f=include%2Fconfigs%2Fsbc8548.h;h=e872e7f81017b764bcf20ee5a08689bca39d82a7;hb=897f70620053e4da07f1173aea3891637b7bb6a9;hp=56c197c0c9f25b6a0f3ae73b125443bae3f1676b;hpb=e6de55ec5bf306df3b3cc8e7a4cc17fa1e78ca6c;p=oweals%2Fu-boot.git

diff --git a/include/configs/sbc8548.h b/include/configs/sbc8548.h
index 56c197c0c9..e872e7f810 100644
--- a/include/configs/sbc8548.h
+++ b/include/configs/sbc8548.h
@@ -13,7 +13,6 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
-
 /*
  * Top level Makefile configuration choices
  */
@@ -37,9 +36,6 @@
 /*
  * High Level Configuration Options
  */
-#define CONFIG_BOOKE		1	/* BOOKE */
-#define CONFIG_E500		1	/* BOOKE e500 family */
-#define CONFIG_MPC8548		1	/* MPC8548 specific */
 #define CONFIG_SBC8548		1	/* SBC8548 board specific */
 
 /*
@@ -71,8 +67,6 @@
 
 #define CONFIG_INTERRUPTS		/* enable pci, srio, ddr interrupts */
 
-#define CONFIG_FSL_LAW		1	/* Use common FSL init code */
-
 /*
  * Below assumes that CCB:SYSCLK remains unchanged at 6:1 via SW2:[1-4]
  */
@@ -92,8 +86,6 @@
  */
 #define CONFIG_ENABLE_36BIT_PHYS	1
 
-#define CONFIG_BOARD_EARLY_INIT_F	1	/* Call board_pre_init */
-
 #undef	CONFIG_SYS_DRAM_TEST			/* memory test, takes time */
 #define CONFIG_SYS_MEMTEST_START	0x00200000	/* memtest works on */
 #define CONFIG_SYS_MEMTEST_END		0x00400000
@@ -102,7 +94,6 @@
 #define CONFIG_SYS_CCSRBAR_PHYS_LOW	CONFIG_SYS_CCSRBAR
 
 /* DDR Setup */
-#define CONFIG_SYS_FSL_DDR2
 #undef CONFIG_FSL_DDR_INTERACTIVE
 #undef CONFIG_DDR_ECC			/* only for ECC DDR module */
 /*
@@ -123,7 +114,6 @@
 #define CONFIG_SYS_SDRAM_BASE		CONFIG_SYS_DDR_SDRAM_BASE
 #define CONFIG_VERY_BIG_RAM
 
-#define CONFIG_NUM_DDR_CONTROLLERS	1
 #define CONFIG_DIMM_SLOTS_PER_CTLR	1
 #define CONFIG_CHIP_SELECTS_PER_CTRL	2
 
@@ -416,9 +406,6 @@
 #define CONFIG_SYS_NS16550_COM1	(CONFIG_SYS_CCSRBAR+0x4500)
 #define CONFIG_SYS_NS16550_COM2	(CONFIG_SYS_CCSRBAR+0x4600)
 
-/* Use the HUSH parser */
-#define CONFIG_SYS_HUSH_PARSER
-
 /*
  * I2C
  */
@@ -465,9 +452,6 @@
 #endif
 
 #if defined(CONFIG_PCI)
-
-#define CONFIG_PCI_PNP			/* do pci plug-and-play */
-
 #undef CONFIG_EEPRO100
 #undef CONFIG_TULIP
 
@@ -475,7 +459,6 @@
 
 #endif	/* CONFIG_PCI */
 
-
 #if defined(CONFIG_TSEC_ENET)
 
 #define CONFIG_MII		1	/* MII PHY management */
@@ -525,20 +508,15 @@
 #define CONFIG_BOOTP_GATEWAY
 #define CONFIG_BOOTP_HOSTNAME
 
-
 /*
  * Command line configuration.
  */
-#define CONFIG_CMD_PING
-#define CONFIG_CMD_I2C
-#define CONFIG_CMD_MII
 #define CONFIG_CMD_REGINFO
 
 #if defined(CONFIG_PCI)
     #define CONFIG_CMD_PCI
 #endif
 
-
 #undef CONFIG_WATCHDOG			/* watchdog disabled */
 
 /*
@@ -589,11 +567,8 @@
 
 #define CONFIG_LOADADDR	1000000	/*default location for tftp and bootm*/
 
-#define CONFIG_BOOTDELAY 10	/* -1 disables auto-boot */
 #undef	CONFIG_BOOTARGS		/* the boot command will set bootargs*/
 
-#define CONFIG_BAUDRATE	115200
-
 #define	CONFIG_EXTRA_ENV_SETTINGS				\
 "netdev=eth0\0"						\
 "uboot=" __stringify(CONFIG_UBOOTPATH) "\0"				\
@@ -606,7 +581,7 @@
 "consoledev=ttyS0\0"				\
 "ramdiskaddr=2000000\0"			\
 "ramdiskfile=uRamdisk\0"			\
-"fdtaddr=c00000\0"				\
+"fdtaddr=1e00000\0"				\
 "fdtfile=sbc8548.dtb\0"
 
 #define CONFIG_NFSBOOTCOMMAND						\
@@ -618,7 +593,6 @@
    "tftp $fdtaddr $fdtfile;"						\
    "bootm $loadaddr - $fdtaddr"
 
-
 #define CONFIG_RAMBOOTCOMMAND \
    "setenv bootargs root=/dev/ram rw "					\
       "console=$consoledev,$baudrate $othbootargs;"			\