X-Git-Url: https://git.librecmc.org/?a=blobdiff_plain;ds=sidebyside;f=include%2Fcommon.h;h=1563d649f01cd869c35fef7f2c2a160f42ee969c;hb=6fc9535f397bace13324546f070e40979ac03d13;hp=68b24d0778d4c2f64b2d608c14293387d130e5d3;hpb=850f788709cef8f7d53d571aec3bfb73b14c5531;p=oweals%2Fu-boot.git

diff --git a/include/common.h b/include/common.h
index 68b24d0778..1563d649f0 100644
--- a/include/common.h
+++ b/include/common.h
@@ -76,6 +76,12 @@ typedef volatile unsigned char	vu_char;
 #ifdef CONFIG_SOC_DA8XX
 #include <asm/arch/hardware.h>
 #endif
+#ifdef CONFIG_FSL_LSCH3
+#include <asm/arch/immap_lsch3.h>
+#endif
+#ifdef CONFIG_FSL_LSCH2
+#include <asm/arch/immap_lsch2.h>
+#endif
 
 #include <part.h>
 #include <flash.h>
@@ -140,9 +146,6 @@ void __assert_fail(const char *assertion, const char *file, unsigned line,
 #define BUG_ON(condition) do { if (unlikely((condition)!=0)) BUG(); } while(0)
 #endif /* BUG */
 
-/* Force a compilation error if condition is true */
-#define BUILD_BUG_ON(condition) ((void)sizeof(char[1 - 2*!!(condition)]))
-
 typedef void (interrupt_handler_t)(void *);
 
 #include <asm/u-boot.h> /* boot information for Linux kernel */
@@ -212,39 +215,32 @@ int run_command_repeatable(const char *cmd, int flag);
  * @return 0 on success, or != 0 on error.
  */
 int run_command_list(const char *cmd, int len, int flag);
-extern char console_buffer[];
 
 /* arch/$(ARCH)/lib/board.c */
 void board_init_f(ulong);
 void board_init_r(gd_t *, ulong) __attribute__ ((noreturn));
 
 /**
- * board_init_f_mem() - Allocate global data and set stack position
+ * ulong board_init_f_alloc_reserve - allocate reserved area
  *
  * This function is called by each architecture very early in the start-up
- * code to set up the environment for board_init_f(). It allocates space for
- * global_data (see include/asm-generic/global_data.h) and places the stack
- * below this.
+ * code to allow the C runtime to reserve space on the stack for writable
+ * 'globals' such as GD and the malloc arena.
  *
- * This function requires a stack[1] Normally this is at @top. The function
- * starts allocating space from 64 bytes below @top. First it creates space
- * for global_data. Then it calls arch_setup_gd() which sets gd to point to
- * the global_data space and can reserve additional bytes of space if
- * required). Finally it allocates early malloc() memory
- * (CONFIG_SYS_MALLOC_F_LEN). The new top of the stack is just below this,
- * and it returned by this function.
+ * @top:	top of the reserve area, growing down.
+ * @return:	bottom of reserved area
+ */
+ulong board_init_f_alloc_reserve(ulong top);
+
+/**
+ * board_init_f_init_reserve - initialize the reserved area(s)
  *
- * [1] Strictly speaking it would be possible to implement this function
- * in C on many archs such that it does not require a stack. However this
- * does not seem hugely important as only 64 byte are wasted. The 64 bytes
- * are used to handle the calling standard which generally requires pushing
- * addresses or registers onto the stack. We should be able to get away with
- * less if this becomes important.
+ * This function is called once the C runtime has allocated the reserved
+ * area on the stack. It must initialize the GD at the base of that area.
  *
- * @top:	Top of available memory, also normally the top of the stack
- * @return:	New stack location
+ * @base:	top from which reservation was done
  */
-ulong board_init_f_mem(ulong top);
+void board_init_f_init_reserve(ulong base);
 
 /**
  * arch_setup_gd() - Set up the global_data pointer
@@ -427,7 +423,6 @@ int get_env_id (void);
 
 void	pci_init      (void);
 void	pci_init_board(void);
-void	pciinfo	      (int, int);
 
 #if defined(CONFIG_PCI) && defined(CONFIG_4xx)
     int	   pci_pre_init	       (struct pci_controller *);
@@ -469,10 +464,7 @@ void	reset_phy     (void);
 void	fdc_hw_init   (void);
 
 /* $(BOARD)/eeprom.c */
-void eeprom_init  (void);
-#ifndef CONFIG_SPI
-int  eeprom_probe (unsigned dev_addr, unsigned offset);
-#endif
+void eeprom_init  (int bus);
 int  eeprom_read  (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cnt);
 int  eeprom_write (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cnt);
 
@@ -826,6 +818,9 @@ int gzwrite(unsigned char *src, int len,
 	    u64 startoffs,
 	    u64 szexpected);
 
+/* lib/lz4_wrapper.c */
+int ulz4fn(const void *src, size_t srcn, void *dst, size_t *dstn);
+
 /* lib/qsort.c */
 void qsort(void *base, size_t nmemb, size_t size,
 	   int(*compar)(const void *, const void *));
@@ -853,15 +848,6 @@ void srand(unsigned int seed);
 unsigned int rand(void);
 unsigned int rand_r(unsigned int *seedp);
 
-/* common/console.c */
-int	console_init_f(void);	/* Before relocation; uses the serial  stuff	*/
-int	console_init_r(void);	/* After  relocation; uses the console stuff	*/
-int	console_assign(int file, const char *devname);	/* Assign the console	*/
-int	ctrlc (void);
-int	had_ctrlc (void);	/* have we had a Control-C since last clear? */
-void	clear_ctrlc (void);	/* clear the Control-C condition */
-int	disable_ctrlc (int);	/* 1 to disable, 0 to enable Control-C detect */
-int confirm_yesno(void);        /*  1 if input is "y", "Y", "yes" or "YES" */
 /*
  * STDIO based functions (can always be used)
  */
@@ -920,13 +906,6 @@ static inline struct in_addr getenv_ip(char *var)
 	return string_to_ip(getenv(var));
 }
 
-/*
- * CONSOLE multiplexing.
- */
-#ifdef CONFIG_CONSOLE_MUX
-#include <iomux.h>
-#endif
-
 int	pcmcia_init (void);
 
 #ifdef CONFIG_STATUS_LED