uint flags;
#ifdef CONFIG_SANDBOX
struct udevice *emul;
+ bool test_mode;
#endif
};
* bus can operate at different speeds (measured in Hz, typically 100KHz
* or 400KHz).
*
- * To obtain this structure, use bus->uclass_priv where bus is the I2C
- * bus udevice.
+ * To obtain this structure, use dev_get_uclass_priv(bus) where bus is the
+ * I2C bus udevice.
*
* @speed_hz: Bus speed in hertz (typically 100000)
*/
int dm_i2c_probe(struct udevice *bus, uint chip_addr, uint chip_flags,
struct udevice **devp);
+/**
+ * dm_i2c_reg_read() - Read a value from an I2C register
+ *
+ * This reads a single value from the given address in an I2C chip
+ *
+ * @addr: Address to read from
+ * @return value read, or -ve on error
+ */
+int dm_i2c_reg_read(struct udevice *dev, uint offset);
+
+/**
+ * dm_i2c_reg_write() - Write a value to an I2C register
+ *
+ * This writes a single value to the given address in an I2C chip
+ *
+ * @addr: Address to write to
+ * @val: Value to write (normally a byte)
+ * @return 0 on success, -ve on error
+ */
+int dm_i2c_reg_write(struct udevice *dev, uint offset, unsigned int val);
+
/**
* dm_i2c_set_bus_speed() - set the speed of a bus
*
*
* @offset_len: New offset length value (typically 1 or 2)
*/
-
int i2c_set_chip_offset_len(struct udevice *dev, uint offset_len);
+
+/**
+ * i2c_get_offset_len() - get the offset length for a chip
+ *
+ * @return: Current offset length value (typically 1 or 2)
+ */
+int i2c_get_chip_offset_len(struct udevice *dev);
+
/**
* i2c_deblock() - recover a bus that is in an unknown state
*
*/
void board_i2c_init(const void *blob);
+/*
+ * Compatibility functions for driver model.
+ */
+uint8_t i2c_reg_read(uint8_t addr, uint8_t reg);
+void i2c_reg_write(uint8_t addr, uint8_t reg, uint8_t val);
+
#endif
/*
* The bus speed value will be updated by the uclass if this function
* does not return an error. This method is optional - if it is not
* provided then the driver can read the speed from
- * bus->uclass_priv->speed_hz
+ * dev_get_uclass_priv(bus)->speed_hz
*
* @bus: Bus to adjust
* @speed: Requested speed in Hz
* Normally this can be provided by the uclass, but if you want your
* driver to check the bus speed by looking at the hardware, you can
* implement that here. This method is optional. This method would
- * normally be expected to return bus->uclass_priv->speed_hz.
+ * normally be expected to return dev_get_uclass_priv(bus)->speed_hz.
*
* @bus: Bus to check
* @return speed of selected I2C bus in Hz, -ve on error