}
#endif
-/**
- * Check if a dt node should be or was bound before relocation.
- *
- * Devicetree nodes can be marked as needed to be bound
- * in the loader stages via special devicetree properties.
- *
- * Before relocation this function can be used to check if nodes
- * are required in either SPL or TPL stages.
- *
- * After relocation and jumping into the real U-Boot binary
- * it is possible to determine if a node was bound in one of
- * SPL/TPL stages.
- *
- * There are 3 settings currently in use
- * -
- * - u-boot,dm-pre-reloc: legacy and indicates any of TPL or SPL
- * Existing platforms only use it to indicate nodes needed in
- * SPL. Should probably be replaced by u-boot,dm-spl for
- * existing platforms.
- * @blob: devicetree
- * @offset: node offset
- *
- * Returns true if node is needed in SPL/TL, false otherwise.
- */
-bool dm_fdt_pre_reloc(const void *blob, int offset);
-
/**
* Check if an of node should be or was bound before relocation.
*
* it is possible to determine if a node was bound in one of
* SPL/TPL stages.
*
- * There are 3 settings currently in use
- * -
+ * There are 4 settings currently in use
+ * - u-boot,dm-pre-proper: U-Boot proper pre-relocation only
* - u-boot,dm-pre-reloc: legacy and indicates any of TPL or SPL
* Existing platforms only use it to indicate nodes needed in
* SPL. Should probably be replaced by u-boot,dm-spl for
* existing platforms.
+ * - u-boot,dm-spl: SPL and U-Boot pre-relocation
+ * - u-boot,dm-tpl: TPL and U-Boot pre-relocation
* @node: of node
*
* Returns true if node is needed in SPL/TL, false otherwise.