#ifndef __CONFIG_H
#define __CONFIG_H
-/*
- * If we are developing, we might want to start armboot from ram
- * so we MUST NOT initialize critical regs like mem-timing ...
- */
-#define CONFIG_INIT_CRITICAL /* undef for developing */
-
#define CONFIG_PXA250 1 /* this is an PXA250 CPU */
#define CONFIG_WEPEP250 1 /* config for wepep250 board */
#undef CONFIG_USE_IRQ /* don't need use IRQ/FIQ */
/*
- * Definition of u-boot build in commands. Check out CONFIG_CMD_DFL if
- * neccessary in include/cmd_confdefs.h file. (Un)comment for getting
- * functionality or size of u-boot code.
+ * BOOTP options
*/
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL \
- & ~CFG_CMD_NET \
- & ~CFG_CMD_LOADS \
- & ~CFG_CMD_CONSOLE \
- & ~CFG_CMD_AUTOSCRIPT \
-/* | CFG_CMD_JFFS2 */ \
- )
-#include <cmd_confdefs.h>
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
+
+#undef CONFIG_CMD_NET
+#undef CONFIG_CMD_LOADS
+#undef CONFIG_CMD_CONSOLE
+#undef CONFIG_CMD_AUTOSCRIPT
+
/*
* Boot options. Setting delay to -1 stops autostart count down.
/*
* Configuration for FLASH memory
*/
-#define CFG_MAX_FLASH_BANKS 1 /* FLASH banks count (not chip count)*/
-#define CFG_MAX_FLASH_SECT 128 /* number of sector in FLASH bank */
-#define WEP_FLASH_BUS_WIDTH 4 /* we use 32 bit FLASH memory... */
+#define CFG_MAX_FLASH_BANKS 1 /* FLASH banks count (not chip count)*/
+#define CFG_MAX_FLASH_SECT 128 /* number of sector in FLASH bank */
+#define WEP_FLASH_BUS_WIDTH 4 /* we use 32 bit FLASH memory... */
#define WEP_FLASH_INTERLEAVE 2 /* ... made of 2 chips */
#define WEP_FLASH_BANK_SIZE 0x2000000 /* size of one flash bank*/
#define WEP_FLASH_SECT_SIZE 0x0040000 /* size of erase sector */
* Right now there is no gain for user, but later on booting kernel might be
* possible. Consider using XIP kernel running from flash to save RAM
* footprint.
- * NOTE: Enable CFG_CMD_JFFS2 for JFFS2 support.
+ * NOTE: Enable CONFIG_CMD_JFFS2 for JFFS2 support.
*/
#define CFG_JFFS2_FIRST_BANK 0
#define CFG_JFFS2_FIRST_SECTOR 5