85xx: remove dummy board_early_init_f

[oweals/u-boot.git] / include / configs / walnut.h

diff --git a/include/configs/walnut.h b/include/configs/walnut.h
index 180549efad38c8ecb53d269aad6c22beea2c17b5..adc420b9ade46063212829eea0543f89ed92391a 100644 (file)
--- a/include/configs/walnut.h
+++ b/include/configs/walnut.h
@@ -43,7 +43,7 @@
 #define CONFIG_SYS_CLK_FREQ    33333333 /* external frequency to pll   */
 
 #define CONFIG_PREBOOT "echo;" \
-       "echo Type \"run flash_nfs\" to mount root filesystem over NFS;" \
+       "echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;" \
        "echo"
 
 #undef CONFIG_BOOTARGS
@@ -73,7 +73,7 @@
        "update=protect off fffc0000 ffffffff;era fffc0000 ffffffff;"   \
                "cp.b 100000 fffc0000 40000;"                           \
                "setenv filesize;saveenv\0"                             \
-       "upd=run load;run update\0"                                     \
+       "upd=run load update\0"                                         \
        ""
 #define CONFIG_BOOTCOMMAND     "run net_nfs"
 
@@ -92,6 +92,7 @@
 #define CONFIG_PHY_ADDR                1       /* PHY address                  */
 
 #define CFG_RX_ETH_BUFFER      16      /* use 16 rx buffer on 405 emac */
+#define CONFIG_HAS_ETH0                1
 
 #define CONFIG_NETCONSOLE              /* include NetConsole support   */
 #define CONFIG_NET_MULTI               /* needed for NetConsole        */
@@ -289,16 +290,6 @@
        (CFG_NVRAM_BASE_ADDR+CFG_NVRAM_SIZE-CFG_ENV_SIZE)       /* Env  */
 #endif
 
-/*-----------------------------------------------------------------------
- * Cache Configuration
- */
-#define CFG_DCACHE_SIZE                16384   /* For AMCC 405 CPUs, older 405 ppc's   */
-                                       /* have only 8kB, 16kB is save here     */
-#define CFG_CACHELINE_SIZE     32      /* ...                  */
-#if defined(CONFIG_CMD_KGDB)
-#define CFG_CACHELINE_SHIFT    5       /* log base 2 of the above value        */
-#endif
-
 /*-----------------------------------------------------------------------
  * External Bus Controller (EBC) Setup
  */
@@ -356,4 +347,9 @@
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed to run kgdb serial port */
 #define CONFIG_KGDB_SER_INDEX  2       /* which serial port to use */
 #endif
+
+/* pass open firmware flat tree */
+#define CONFIG_OF_LIBFDT       1
+#define CONFIG_OF_BOARD_SETUP  1
+
 #endif /* __CONFIG_H */