configs: ls1012a: Enable CONFIG_SPI_FLASH_SPANSION in defconfigs

[oweals/u-boot.git] / include / configs / strider.h

diff --git a/include/configs/strider.h b/include/configs/strider.h
index e4584db7d5d792c088ef4632445a66c2d0afac08..d5f710be592f0f05289e8a1152aec86b99c0248d 100644 (file)
--- a/include/configs/strider.h
+++ b/include/configs/strider.h
@@ -24,9 +24,7 @@
 /*
  * DDR Setup
  */
-#define CONFIG_SYS_DDR_BASE            0x00000000 /* DDR is system memory */
-#define CONFIG_SYS_SDRAM_BASE          CONFIG_SYS_DDR_BASE
-#define CONFIG_SYS_DDR_SDRAM_BASE      CONFIG_SYS_DDR_BASE
+#define CONFIG_SYS_SDRAM_BASE          0x00000000 /* DDR is system memory */
 #define CONFIG_SYS_DDR_SDRAM_CLK_CNTL  DDR_SDRAM_CLK_CNTL_CLK_ADJUST_05
 #define CONFIG_SYS_DDRCDR_VALUE        (DDRCDR_EN \
                                | DDRCDR_PZ_LOZ \
@@ -92,8 +90,6 @@
 /*
  * Memory test
  */
-#define CONFIG_SYS_MEMTEST_START       0x00001000 /* memtest region */
-#define CONFIG_SYS_MEMTEST_END         0x07f00000
 
 /*
  * The reserved memory
@@ -112,13 +108,6 @@
 #define CONFIG_SYS_GBL_DATA_OFFSET     \
        (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 
-/*
- * Local Bus Configuration & Clock Setup
- */
-#define CONFIG_SYS_LCRR_DBYP           LCRR_DBYP
-#define CONFIG_SYS_LCRR_CLKDIV         LCRR_CLKDIV_2
-#define CONFIG_SYS_LBC_LBCR            0x00040000
-
 /*
  * FLASH on the Local Bus
  */
@@ -136,14 +125,6 @@
 #define CONFIG_SYS_FLASH_ERASE_TOUT    60000 /* Flash Erase Timeout (ms) */
 #define CONFIG_SYS_FLASH_WRITE_TOUT    500 /* Flash Write Timeout (ms) */
 
-/*
- * FPGA
- */
-#define CONFIG_SYS_FPGA0_BASE          0xE0600000
-#define CONFIG_SYS_FPGA0_SIZE          1 /* FPGA size is 1M */
-
-
-#define CONFIG_SYS_FPGA_BASE(k)                CONFIG_SYS_FPGA0_BASE
 #define CONFIG_SYS_FPGA_DONE(k)                0x0010
 
 #define CONFIG_SYS_FPGA_COUNT          1
@@ -343,7 +324,6 @@ void fpga_control_clear(unsigned int bus, int pin);
 /*
  * Software (bit-bang) MII driver configuration
  */
-#define CONFIG_BITBANGMII              /* bit-bang MII PHY management */
 #define CONFIG_BITBANGMII_MULTI
 
 /*
@@ -401,16 +381,6 @@ void fpga_control_clear(unsigned int bus, int pin);
 /*
  * Environment
  */
-#if 1
-#define CONFIG_ENV_ADDR                (CONFIG_SYS_MONITOR_BASE + \
-                                CONFIG_SYS_MONITOR_LEN)
-#define CONFIG_ENV_SECT_SIZE   0x10000 /* 64K(one sector) for env */
-#define CONFIG_ENV_SIZE                0x2000
-#define CONFIG_ENV_ADDR_REDUND (CONFIG_ENV_ADDR + CONFIG_ENV_SECT_SIZE)
-#define CONFIG_ENV_SIZE_REDUND CONFIG_ENV_SIZE
-#else
-#define CONFIG_ENV_SIZE                0x2000          /* 8KB */
-#endif
 
 #define CONFIG_LOADS_ECHO      1       /* echo on for serial download */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   1       /* allow baudrate change */
@@ -453,8 +423,6 @@ void fpga_control_clear(unsigned int bus, int pin);
 #define CONFIG_ROOTPATH                "/opt/nfsroot"
 #define CONFIG_BOOTFILE                "uImage"
 
-#define CONFIG_PREBOOT         /* enable preboot variable */
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                                       \
        "netdev=eth0\0"                                                 \
        "consoledev=ttyS1\0"                                            \