arc: add Arcangel4 board support

[oweals/u-boot.git] / include / configs / snapper9260.h

diff --git a/include/configs/snapper9260.h b/include/configs/snapper9260.h
index 383d1ce01367e0ab6d9b4c34357d12e5707d42ae..94a65c4d01c84c36586da6e8bbd65fcaae7053d1 100644 (file)
--- a/include/configs/snapper9260.h
+++ b/include/configs/snapper9260.h
@@ -20,7 +20,6 @@
 /* ARM asynchronous clock */
 #define CONFIG_SYS_AT91_MAIN_CLOCK     18432000 /* External Crystal, in Hz */
 #define CONFIG_SYS_AT91_SLOW_CLOCK     32768
-#define CONFIG_SYS_HZ                  1000
 
 /* CPU */
 #define CONFIG_ARCH_CPU_INIT
@@ -60,11 +59,13 @@
 #define CONFIG_RMII
 #define CONFIG_NET_RETRY_COUNT         20
 #define CONFIG_RESET_PHY_R
+#define CONFIG_AT91_WANTS_COMMON_PHY
 #define CONFIG_TFTP_PORT
 #define CONFIG_TFTP_TSIZE
 
 /* USB */
 #define CONFIG_USB_ATMEL
+#define CONFIG_USB_ATMEL_CLK_SEL_PLLB
 #define CONFIG_USB_OHCI_NEW
 #define CONFIG_DOS_PARTITION
 #define CONFIG_SYS_USB_OHCI_CPU_INIT
@@ -74,7 +75,6 @@
 #define CONFIG_USB_STORAGE
 
 /* GPIOs and IO expander */
-#define CONFIG_AT91_LEGACY
 #define CONFIG_ATMEL_LEGACY
 #define CONFIG_AT91_GPIO
 #define CONFIG_AT91_GPIO_PULLUP                1
@@ -90,11 +90,11 @@
 #define CONFIG_SYS_PROMPT              "Snapper> "
 
 /* I2C - Bit-bashed */
-#define CONFIG_SOFT_I2C
-#define CONFIG_SYS_I2C_SPEED           100000
-#define CONFIG_SYS_I2C_SLAVE           0x7F
+#define CONFIG_SYS_I2C
+#define CONFIG_SYS_I2C_SOFT            /* I2C bit-banged */
+#define CONFIG_SYS_I2C_SOFT_SPEED      100000
+#define CONFIG_SYS_I2C_SOFT_SLAVE      0x7F
 #define CONFIG_SOFT_I2C_READ_REPEATED_START
-#define CONFIG_I2C_MULTI_BUS
 #define I2C_INIT do {                                                  \
                at91_set_gpio_output(AT91_PIN_PA23, 1);                 \
                at91_set_gpio_output(AT91_PIN_PA24, 1);                 \