/* check for keypress on bootdelay==0 */
/*#define CONFIG_ZERO_BOOTDELAY_CHECK*/
+#define CONFIG_SYS_TEXT_BASE 0x0FFC0000
#define CONFIG_SYS_SDRAM_BASE (0x08000000)
#define CONFIG_SYS_SDRAM_SIZE (128 * 1024 * 1024)
#define CONFIG_SYS_BAUDRATE_TABLE { 115200, 57600, 38400, 19200, 9600 }
#define CONFIG_SYS_MEMTEST_START (CONFIG_SYS_SDRAM_BASE)
-#define CONFIG_SYS_MEMTEST_END (TEXT_BASE - 0x100000)
+#define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_TEXT_BASE - 0x100000)
/* Flash board support */
#define CONFIG_SYS_FLASH_BASE (0xA0000000)
/* Size of DRAM reserved for malloc() use */
#define CONFIG_SYS_MALLOC_LEN (1204 * 1024)
-/* size in bytes reserved for initial data */
-#define CONFIG_SYS_GBL_DATA_SIZE (256)
#define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024)
#define CONFIG_SYS_RX_ETH_BUFFER (8)
/* Board Clock */
#define CONFIG_SYS_CLK_FREQ 33333333
-#define TMU_CLK_DIVIDER 4
+#define CONFIG_SYS_TMU_CLK_DIV 4
#define CONFIG_SYS_HZ 1000
/* PCI Controller */
#define CONFIG_PCI_IO_BUS 0xFE200000 /* IO space base address */
#define CONFIG_PCI_IO_PHYS CONFIG_PCI_IO_BUS
#define CONFIG_PCI_IO_SIZE 0x00200000 /* Size of IO window */
+#define CONFIG_PCI_SYS_PHYS CONFIG_SYS_SDRAM_BASE
+#define CONFIG_PCI_SYS_BUS CONFIG_SYS_SDRAM_BASE
+#define CONFIG_PCI_SYS_SIZE CONFIG_SYS_SDRAM_SIZE
#endif /* CONFIG_CMD_PCI */
#if defined(CONFIG_CMD_NET)
#define CONFIG_NET_MULTI
#define CONFIG_RTL8169
*/
-/* AX88696L Support(NE2000 base chip) */
-#define CONFIG_DRIVER_NE2000
+/* AX88796L Support(NE2000 base chip) */
#define CONFIG_DRIVER_AX88796L
#define CONFIG_DRIVER_NE2000_BASE 0xA4100000
#endif
#define CONFIG_SYS_ATA_DATA_OFFSET 0x1000 /* data reg offset */
#define CONFIG_SYS_ATA_REG_OFFSET 0x1000 /* reg offset */
#define CONFIG_SYS_ATA_ALT_OFFSET 0x800 /* alternate register offset */
+#define CONFIG_IDE_SWAP_IO
#endif /* CONFIG_CMD_IDE */
#endif /* __R7780RP_H */