Merge branch 'master' of git://www.denx.de/git/u-boot-imx

[oweals/u-boot.git] / include / configs / p1_twr.h

diff --git a/include/configs/p1_twr.h b/include/configs/p1_twr.h
index c296a0759947f2c1081cd91a931302ae10092805..77ba2d8bedb70edf9c7fbc1086f47ccc2e001728 100644 (file)
--- a/include/configs/p1_twr.h
+++ b/include/configs/p1_twr.h
@@ -10,6 +10,7 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
+#define        CONFIG_DISPLAY_BOARDINFO
 #if defined(CONFIG_TWR_P1025)
 #define CONFIG_BOARDNAME "TWR-P1025"
 #define CONFIG_P1025
@@ -202,7 +203,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
                                        GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
-#define CONFIG_SYS_MONITOR_LEN (512 * 1024)/* Reserve 512 kB for Mon */
+#define CONFIG_SYS_MONITOR_LEN (768 * 1024)
 #define CONFIG_SYS_MALLOC_LEN  (1024 * 1024)/* Reserved for malloc */
 
 #define CONFIG_SYS_BR0_PRELIM  CONFIG_FLASH_BR_PRELIM  /* NOR Base Address */
@@ -214,7 +215,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
  */
 #define CONFIG_CONS_INDEX              1
 #undef CONFIG_SERIAL_SOFTWARE_FIFO
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK         get_bus_freq(0)
@@ -261,7 +261,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 /* enable read and write access to EEPROM */
 #define CONFIG_CMD_EEPROM
-#define CONFIG_SYS_I2C_MULTI_EEPROMS
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -270,7 +269,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
  * eSPI - Enhanced SPI
  */
 #define CONFIG_HARD_SPI
-#define CONFIG_FSL_ESPI
 
 #if defined(CONFIG_PCI)
 /*
@@ -300,11 +298,8 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_PCIE1_IO_PHYS       0xffc00000
 #define CONFIG_SYS_PCIE1_IO_SIZE       0x00010000      /* 64k */
 
-#define CONFIG_NET_MULTI
 #define CONFIG_PCI_PNP /* do pci plug-and-play */
-#define CONFIG_E1000   /* Defind e1000 pci Ethernet card*/
 #define CONFIG_CMD_PCI
-#define CONFIG_CMD_NET
 
 #define CONFIG_PCI_SCAN_SHOW   /* show pci devices on startup */
 #define CONFIG_DOS_PARTITION
@@ -312,10 +307,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 #if defined(CONFIG_TSEC_ENET)
 
-#ifndef CONFIG_NET_MULTI
-#define CONFIG_NET_MULTI
-#endif
-
 #define CONFIG_MII             /* MII PHY management */
 #define CONFIG_TSEC1
 #define CONFIG_TSEC1_NAME      "eTSEC1"
@@ -348,7 +339,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #ifdef CONFIG_QE
 /* QE microcode/firmware address */
 #define CONFIG_SYS_QE_FMAN_FW_IN_NOR
-#define CONFIG_SYS_QE_FMAN_FW_ADDR     0xefec0000
+#define CONFIG_SYS_QE_FW_ADDR  0xefec0000
 #define CONFIG_SYS_QE_FMAN_FW_LENGTH   0x10000
 #endif /* CONFIG_QE */
 
@@ -388,6 +379,18 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #endif /* CONFIG_UEC_ETH5 */
 #endif /* CONFIG_TWR-P1025 */
 
+/*
+ * Dynamic MTD Partition support with mtdparts
+ */
+#define CONFIG_MTD_DEVICE
+#define CONFIG_MTD_PARTITIONS
+#define CONFIG_CMD_MTDPARTS
+#define CONFIG_FLASH_CFI_MTD
+#define MTDIDS_DEFAULT "nor0=ec000000.nor"
+#define MTDPARTS_DEFAULT "mtdparts=ec000000.nor:256k(vsc7385-firmware)," \
+                       "256k(dtb),5632k(kernel),57856k(fs)," \
+                       "256k(qe-ucode-firmware),1280k(u-boot)"
+
 /*
  * Environment
  */
@@ -414,14 +417,10 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #define CONFIG_CMD_IRQ
 #define CONFIG_CMD_PING
 #define CONFIG_CMD_I2C
 #define CONFIG_CMD_MII
-#define CONFIG_CMD_ELF
-#define CONFIG_CMD_SETEXPR
 #define CONFIG_CMD_REGINFO
 
 /*