#define CONFIG_OMAP 1 /* in a TI OMAP core */
#define CONFIG_OMAP34XX 1 /* which is a 34XX */
#define CONFIG_OMAP3_ZOOM2 1 /* working with Zoom II */
+#define CONFIG_OMAP_GPIO
#define CONFIG_SDRC /* The chip has SDRC controller */
#define V_OSCK 26000000 /* Clock output from T2 */
#define V_SCLK (V_OSCK >> 1)
-#undef CONFIG_USE_IRQ /* no support for IRQs */
#define CONFIG_MISC_INIT_R
#define CONFIG_CMDLINE_TAG 1 /* enable passing of ATAGs */
* NS16550 Configuration
* Zoom2 uses the TL16CP754C on the debug board
*/
-#define CONFIG_SERIAL_MULTI 1
/*
* 0 - 1 : first USB with respect to the left edge of the debug board
* 2 - 3 : second USB with respect to the left edge of the debug board
*/
-#define ZOOM2_DEFAULT_SERIAL_DEVICE (&zoom2_serial_device0)
+#define ZOOM2_DEFAULT_SERIAL_DEVICE 0
#define V_NS16550_CLK (1843200) /* 1.8432 Mhz */
#define CONFIG_OMAP_HSMMC 1
#define CONFIG_DOS_PARTITION 1
-/* DDR - I use Micron DDR */
-#define CONFIG_OMAP3_MICRON_DDR 1
-
/* Status LED */
#define CONFIG_STATUS_LED 1 /* Status LED enabled */
#define CONFIG_BOARD_SPECIFIC_LED 1
#define CONFIG_SYS_PTV 7 /* 2^(PTV+1) */
#define CONFIG_SYS_HZ ((V_SCLK) / (2 << CONFIG_SYS_PTV))
-/*-----------------------------------------------------------------------
- * Stack sizes
- *
- * The stack sizes are set up in start.S using these settings
- */
-#define CONFIG_STACKSIZE (128 << 10) /* regular stack 128 KiB */
-#ifdef CONFIG_USE_IRQ
-#define CONFIG_STACKSIZE_IRQ (4 << 10) /* IRQ stack 4 KiB */
-#define CONFIG_STACKSIZE_FIQ (4 << 10) /* FIQ stack 4 KiB */
-#endif
-
/*-----------------------------------------------------------------------
* Physical Memory Map
*/
#define PHYS_SDRAM_1_SIZE (32 << 20) /* at least 32 MiB */
#define PHYS_SDRAM_2 OMAP34XX_SDRC_CS1
-/* SDRAM Bank Allocation method */
-#define SDRC_R_B_C 1
-
/*-----------------------------------------------------------------------
* FLASH and environment organization
*/