5xxx: Cleanup for partial linking and --gc-sections
[oweals/u-boot.git] / include / configs / omap3_evm.h
index a8d4105fbdcc70b6e9de128509c7c2bc60457586..84b29866bcc0c796c2c9d0a5c16d292a4dcba2a5 100644 (file)
 /*
  * High Level Configuration Options
  */
-#define CONFIG_ARMCORTEXA8     1       /* This is an ARM V7 CPU core */
+#define CONFIG_ARMV7           1       /* This is an ARM V7 CPU core */
 #define CONFIG_OMAP            1       /* in a TI OMAP core */
 #define CONFIG_OMAP34XX                1       /* which is a 34XX */
 #define CONFIG_OMAP3430                1       /* which is in a 3430 */
 #define CONFIG_OMAP3_EVM       1       /* working with EVM */
 
+#define CONFIG_SDRC    /* The chip has SDRC controller */
+
 #include <asm/arch/cpu.h>      /* get chip and board defs */
 #include <asm/arch/omap3.h>
 
@@ -69,7 +71,6 @@
 #define CONFIG_ENV_SIZE                        (128 << 10)     /* 128 KiB */
                                                /* Sector */
 #define CONFIG_SYS_MALLOC_LEN          (CONFIG_ENV_SIZE + (128 << 10))
-#define CONFIG_SYS_GBL_DATA_SIZE       128     /* bytes reserved for */
                                                /* initial data */
 /*
  * Hardware drivers
 
 #define CONFIG_CMD_I2C         /* I2C serial bus support       */
 #define CONFIG_CMD_MMC         /* MMC support                  */
-#define CONFIG_CMD_ONENAND     /* ONENAND support              */
+#define CONFIG_CMD_NAND                /* NAND support                 */
 #define CONFIG_CMD_DHCP
 #define CONFIG_CMD_PING
 
 #define PISMO1_NAND_SIZE               GPMC_SIZE_128M
 #define PISMO1_ONEN_SIZE               GPMC_SIZE_128M
 
-#define CONFIG_SYS_MAX_FLASH_SECT      520     /* max number of sectors */
-                                               /* on one chip */
-#define CONFIG_SYS_MAX_FLASH_BANKS     2       /* max number of flash banks */
 #define CONFIG_SYS_MONITOR_LEN         (256 << 10)     /* Reserve 2 sectors */
 
 #define CONFIG_SYS_FLASH_BASE          boot_flash_base
 #define CONFIG_SYS_MONITOR_BASE                CONFIG_SYS_FLASH_BASE
 #define CONFIG_SYS_ONENAND_BASE                ONENAND_MAP
 
+#if defined(CONFIG_CMD_NAND)
+#define CONFIG_NAND_OMAP_GPMC
+#define GPMC_NAND_ECC_LP_x16_LAYOUT    1
+#define CONFIG_ENV_IS_IN_NAND
+#elif defined(CONFIG_CMD_ONENAND)
 #define CONFIG_ENV_IS_IN_ONENAND       1
+#endif
 #define ONENAND_ENV_OFFSET             0x260000 /* environment starts here */
 #define SMNAND_ENV_OFFSET              0x260000 /* environment starts here */
 
 #define CONFIG_ENV_OFFSET              boot_flash_off
 #define CONFIG_ENV_ADDR                        boot_flash_env_addr
 
-/*-----------------------------------------------------------------------
- * CFI FLASH driver setup
- */
-/* timeout values are in ticks */
-#define CONFIG_SYS_FLASH_ERASE_TOUT    (100 * CONFIG_SYS_HZ)
-#define CONFIG_SYS_FLASH_WRITE_TOUT    (100 * CONFIG_SYS_HZ)
-
-/* Flash banks JFFS2 should use */
-#define CONFIG_SYS_MAX_MTD_BANKS       (CONFIG_SYS_MAX_FLASH_BANKS + \
-                                       CONFIG_SYS_MAX_NAND_DEVICE)
-#define CONFIG_SYS_JFFS2_MEM_NAND
-/* use flash_info[2] */
-#define CONFIG_SYS_JFFS2_FIRST_BANK    CONFIG_SYS_MAX_FLASH_BANKS
-#define CONFIG_SYS_JFFS2_NUM_BANKS     1
-
 #ifndef __ASSEMBLY__
-extern struct gpmc *gpmc_cfg;
 extern unsigned int boot_flash_base;
 extern volatile unsigned int boot_flash_env_addr;
 extern unsigned int boot_flash_off;
@@ -338,6 +326,17 @@ extern unsigned int boot_flash_sec;
 extern unsigned int boot_flash_type;
 #endif
 
+/*
+ * Support for relocation
+ */
+#define CONFIG_SYS_SDRAM_BASE          PHYS_SDRAM_1
+#define CONFIG_SYS_INIT_SP_ADDR                (LOW_LEVEL_SRAM_STACK - CONFIG_SYS_GBL_DATA_SIZE)
+
+/*
+ * Define the board revision statically
+ */
+/* #define CONFIG_STATIC_BOARD_REV     OMAP3EVM_BOARD_GEN_2 */
+
 /*----------------------------------------------------------------------------
  * SMSC9115 Ethernet from SMSC9118 family
  *----------------------------------------------------------------------------