#define CONFIG_INITRD_TAG 1
#define CONFIG_SILENT_CONSOLE 1 /* enable silent startup */
-#define CFG_CONSOLE_INFO_QUIET
+#define CONFIG_SYS_CONSOLE_INFO_QUIET
/*
* Physical Memory Map
#define PHYS_SDRAM_1_SIZE (64 * 1024 * 1024)
#define PHYS_FLASH_1 0x00000000 /* Flash Bank #1 */
-/*
- * FLASH organization
- */
-#define CFG_FLASH_BASE PHYS_FLASH_1
-#define CFG_MAX_FLASH_BANKS 1
-#define PHYS_FLASH_1_SIZE (1 * 1024 * 1024)
-#define CFG_MAX_FLASH_SECT 19
-#define CFG_FLASH_ERASE_TOUT (5*CFG_HZ) /* in ticks */
-#define CFG_FLASH_WRITE_TOUT (5*CFG_HZ)
-
-#define CFG_MONITOR_BASE PHYS_FLASH_1
-#define CFG_MONITOR_LEN (256 * 1024)
+#define CONFIG_SYS_MONITOR_BASE PHYS_FLASH_1
+#define CONFIG_SYS_MONITOR_LEN (256 * 1024)
/*
* Environment settings
*/
-#define CFG_ENV_IS_IN_FLASH
-#define CFG_ENV_ADDR 0x4000
-#define CFG_ENV_SIZE (8 * 1024)
-#define CFG_ENV_SECT_SIZE (8 * 1024)
-#define CFG_ENV_ADDR_REDUND 0x6000
-#define CFG_ENV_SIZE_REDUND CFG_ENV_SIZE
+#define CONFIG_ENV_IS_IN_FLASH
+#define CONFIG_ENV_ADDR 0x4000
+#define CONFIG_ENV_SIZE (8 * 1024)
+#define CONFIG_ENV_SECT_SIZE (8 * 1024)
+#define CONFIG_ENV_ADDR_REDUND 0x6000
+#define CONFIG_ENV_SIZE_REDUND CONFIG_ENV_SIZE
#define CONFIG_ENV_OVERWRITE
/*
* Size of malloc() pool
*/
-#define CFG_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
-#define CFG_MALLOC_LEN (4 * 1024 * 1024)
+#define CONFIG_SYS_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
+#define CONFIG_SYS_MALLOC_LEN (4 * 1024 * 1024)
/*
* The stack size is set up in start.S using the settings below
/*
* Hardware drivers
*/
+#define CONFIG_SYS_NS16550
+#define CONFIG_SYS_NS16550_SERIAL
+#define CONFIG_SYS_NS16550_REG_SIZE (-4)
+#define CONFIG_SYS_NS16550_CLK (CONFIG_XTAL_FREQ) /* can be 12M/32Khz or 48Mhz */
+#define CONFIG_SYS_NS16550_COM1 OMAP1510_UART1_BASE /* uart1 */
+
#define CONFIG_DRIVER_SMC91111
-#define CONFIG_SMC91111_BASE 0x04000300
+#define CONFIG_SMC91111_BASE 0x04000300
-/*
- * NS16550 Configuration
- */
-#define CFG_NS16550
-#define CFG_NS16550_SERIAL
-#define CFG_NS16550_REG_SIZE (-4)
-#define CFG_NS16550_CLK (CONFIG_XTAL_FREQ) /* can be 12M/32Khz or 48Mhz */
-#define CFG_NS16550_COM1 OMAP1510_UART1_BASE /* uart1 */
+#define CONFIG_SYS_FLASH_BASE PHYS_FLASH_1
+#define CONFIG_SYS_MAX_FLASH_BANKS 1
+#define CONFIG_SYS_MAX_FLASH_SECT 19
+
+#define CONFIG_SYS_FLASH_CFI
+#define CONFIG_FLASH_CFI_DRIVER
+#define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT
+#define CONFIG_FLASH_CFI_LEGACY
+#define CONFIG_SYS_FLASH_LEGACY_512Kx16
+
+#define CONFIG_SYS_MAX_NAND_DEVICE 1
+#define CONFIG_SYS_NAND_BASE 0x04000000 + (2 << 23)
+#define NAND_ALLOW_ERASE_ALL 1
-#define CONFIG_CONS_INDEX 1
-#define CONFIG_BAUDRATE 115200
-#define CFG_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
+#define CONFIG_HARD_I2C
+#define CONFIG_SYS_I2C_SPEED 100000
+#define CONFIG_SYS_I2C_SLAVE 1
+#define CONFIG_DRIVER_OMAP1510_I2C
+
+#define CONFIG_RTC_DS1307
+#define CONFIG_SYS_I2C_RTC_ADDR 0x68
+
+
+#define CONFIG_CONS_INDEX 1
+#define CONFIG_BAUDRATE 115200
+#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
/*#define CONFIG_SKIP_RELOCATE_UBOOT*/
/*#define CONFIG_SKIP_LOWLEVEL_INIT */
-/*
- * NAND flash
- */
-#define CFG_MAX_NAND_DEVICE 1
-#define NAND_MAX_CHIPS 1
-#define CFG_NAND_BASE 0x04000000 + (2 << 23)
-#define NAND_ALLOW_ERASE_ALL 1
-
/*
* partitions (mtdparts command line support)
*/
-#define CONFIG_JFFS2_CMDLINE
+#define CONFIG_CMD_MTDPARTS
#define MTDIDS_DEFAULT "nor0=omapflash.0,nand0=omapnand.0"
#define MTDPARTS_DEFAULT "mtdparts=" \
"omapflash.0:8k@16k(env),8k(r_env),448k@576k(u-boot);" \
/*
* Command line configuration.
*/
-
#define CONFIG_CMD_BDI
#define CONFIG_CMD_BOOTD
+#define CONFIG_CMD_DATE
#define CONFIG_CMD_DHCP
-#define CONFIG_CMD_ENV
+#define CONFIG_CMD_SAVEENV
#define CONFIG_CMD_FLASH
#define CONFIG_CMD_IMI
#define CONFIG_CMD_JFFS2
#define CONFIG_BOOTDELAY 3
#define CONFIG_ZERO_BOOTDELAY_CHECK /* allow to break in always */
#undef CONFIG_BOOTARGS /* the boot command will set bootargs*/
-#define CFG_AUTOLOAD "n" /* No autoload */
+#define CONFIG_SYS_AUTOLOAD "n" /* No autoload */
#define CONFIG_BOOTCOMMAND "run fboot"
#define CONFIG_PREBOOT "run setup"
#define CONFIG_EXTRA_ENV_SETTINGS \
#if 0 /* feel free to disable for development */
#define CONFIG_AUTOBOOT_KEYED /* Enable password protection */
-#define CONFIG_AUTOBOOT_PROMPT "\nNetStar PBX - boot in %d secs...\n"
+#define CONFIG_AUTOBOOT_PROMPT \
+ "\nNetStar PBX - boot in %d secs...\n", bootdelay
#define CONFIG_AUTOBOOT_DELAY_STR "." /* 1st "password" */
#endif
/*
* Miscellaneous configurable options
*/
-#define CFG_LONGHELP /* undef to save memory */
-#define CFG_PROMPT "# " /* Monitor Command Prompt */
-#define CFG_CBSIZE 256 /* Console I/O Buffer Size */
-#define CFG_PBSIZE (CFG_CBSIZE+sizeof(CFG_PROMPT)+16) /* Print Buffer Size */
-#define CFG_MAXARGS 16 /* max number of command args */
-#define CFG_BARGSIZE CFG_CBSIZE /* Boot Argument Buffer Size */
-
-#define CFG_HUSH_PARSER
-#define CFG_PROMPT_HUSH_PS2 "> "
+#define CONFIG_SYS_LONGHELP /* undef to save memory */
+#define CONFIG_SYS_PROMPT "# " /* Monitor Command Prompt */
+#define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */
+#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */
+#define CONFIG_SYS_MAXARGS 16 /* max number of command args */
+#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */
+
+#define CONFIG_SYS_HUSH_PARSER
+#define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
#define CONFIG_AUTO_COMPLETE
-#define CFG_MEMTEST_START PHYS_SDRAM_1
-#define CFG_MEMTEST_END PHYS_SDRAM_1 + PHYS_SDRAM_1_SIZE - \
- (CFG_MONITOR_LEN + CFG_MALLOC_LEN + CONFIG_STACKSIZE)
-
-#undef CFG_CLKS_IN_HZ /* everything, incl board info, in Hz */
+#define CONFIG_SYS_MEMTEST_START PHYS_SDRAM_1
+#define CONFIG_SYS_MEMTEST_END PHYS_SDRAM_1 + PHYS_SDRAM_1_SIZE - \
+ (CONFIG_SYS_MONITOR_LEN + CONFIG_SYS_MALLOC_LEN + CONFIG_STACKSIZE)
-#define CFG_LOAD_ADDR PHYS_SDRAM_1 + 0x400000 /* default load address */
+#define CONFIG_SYS_LOAD_ADDR PHYS_SDRAM_1 + 0x400000 /* default load address */
/* The 1510 has 3 timers, they can be driven by the RefClk (12Mhz) or by DPLL1.
* This time is further subdivided by a local divisor.
*/
-#define CFG_TIMERBASE OMAP1510_TIMER1_BASE
-#define CFG_PVT 7 /* 2^(pvt+1), divide by 256 */
-#define CFG_HZ ((CONFIG_SYS_CLK_FREQ)/(2 << CFG_PVT))
+#define CONFIG_SYS_TIMERBASE OMAP1510_TIMER1_BASE
+#define CONFIG_SYS_PTV 7 /* 2^(pvt+1), divide by 256 */
+#define CONFIG_SYS_HZ ((CONFIG_SYS_CLK_FREQ)/(2 << CONFIG_SYS_PTV))
#define OMAP5910_DPLL_DIV 1
#define OMAP5910_DPLL_MUL ((CONFIG_SYS_CLK_FREQ * \