ARM: zynq: Use {} around variables for qspi and nand boot cmds

[oweals/u-boot.git] / include / configs / mx7dsabresd.h

diff --git a/include/configs/mx7dsabresd.h b/include/configs/mx7dsabresd.h
index 11fcc9f158be73d658aee9768b7bcffc4020d8d4..e1f92da48ca6b340a18208274de7a98555fb6e75 100644 (file)
--- a/include/configs/mx7dsabresd.h
+++ b/include/configs/mx7dsabresd.h
@@ -10,7 +10,6 @@
 
 #include "mx7_common.h"
 
-#define CONFIG_DBG_MONITOR
 #define PHYS_SDRAM_SIZE                        SZ_1G
 
 #define CONFIG_MXC_UART_BASE            UART1_IPS_BASE_ADDR
@@ -31,15 +30,10 @@
 /* MMC Config*/
 #define CONFIG_SYS_FSL_ESDHC_ADDR       0
 
-#undef CONFIG_BOOTM_NETBSD
-#undef CONFIG_BOOTM_PLAN9
-#undef CONFIG_BOOTM_RTEMS
-
 /* I2C configs */
 #define CONFIG_SYS_I2C_MXC
 #define CONFIG_SYS_I2C_SPEED           100000
 
-#define CONFIG_SUPPORT_EMMC_BOOT       /* eMMC specific */
 #define CONFIG_SYS_MMC_IMG_LOAD_PART   1
 
 #ifdef CONFIG_IMX_BOOTAUX
@@ -225,13 +219,7 @@
 #endif
 
 #ifdef CONFIG_FSL_QSPI
-#define CONFIG_SPI_FLASH
-#define CONFIG_SPI_FLASH_MACRONIX
-#define CONFIG_SPI_FLASH_BAR
-#define CONFIG_SF_DEFAULT_BUS          0
-#define CONFIG_SF_DEFAULT_CS           0
-#define CONFIG_SF_DEFAULT_SPEED                40000000
-#define CONFIG_SF_DEFAULT_MODE         SPI_MODE_0
+#define CONFIG_SYS_FSL_QSPI_AHB
 #define FSL_QSPI_FLASH_NUM             1
 #define FSL_QSPI_FLASH_SIZE            SZ_64M
 #define QSPI0_BASE_ADDR                        QSPI1_IPS_BASE_ADDR