#ifndef __CONFIG_H
#define __CONFIG_H
-/*
- * If we are developing, we might want to start armboot from ram
- * so we MUST NOT initialize critical regs like mem-timing ...
- */
-#define CONFIG_INIT_CRITICAL /* undef for developing */
-
/*
* High Level Configuration Options
* (easy to change)
#define CONFIG_PXA250 1 /* This is an PXA250 CPU */
#define CONFIG_LUBBOCK 1 /* on an LUBBOCK Board */
#define CONFIG_LCD 1
+#ifdef CONFIG_LCD
+#define CONFIG_SHARP_LM8V31
+#endif
#define CONFIG_MMC 1
#define BOARD_LATE_INIT 1
+#define CONFIG_DOS_PARTITION
#undef CONFIG_USE_IRQ /* we don't need IRQ/FIQ stuff */
/*
* Size of malloc() pool
*/
-#define CFG_MALLOC_LEN (CFG_ENV_SIZE + 128*1024)
-#define CFG_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
+#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024)
+#define CONFIG_SYS_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
/*
* Hardware drivers
#define CONFIG_BAUDRATE 115200
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL | CFG_CMD_MMC | CFG_CMD_FAT)
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
+
+#define CONFIG_CMD_MMC
+#define CONFIG_CMD_FAT
+
#define CONFIG_BOOTDELAY 3
#define CONFIG_ETHADDR 08:00:3e:26:0a:5b
#define CONFIG_NETMASK 255.255.0.0
#define CONFIG_IPADDR 192.168.0.21
#define CONFIG_SERVERIP 192.168.0.250
-#define CONFIG_BOOTCOMMAND "bootm 40000"
+#define CONFIG_BOOTCOMMAND "bootm 80000"
#define CONFIG_BOOTARGS "root=/dev/mtdblock2 rootfstype=cramfs console=ttyS0,115200"
#define CONFIG_CMDLINE_TAG
+#define CONFIG_TIMESTAMP
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CONFIG_KGDB_BAUDRATE 230400 /* speed to run kgdb serial port */
#define CONFIG_KGDB_SER_INDEX 2 /* which serial port to use */
#endif
/*
* Miscellaneous configurable options
*/
-#define CFG_HUSH_PARSER 1
-#define CFG_PROMPT_HUSH_PS2 "> "
+#define CONFIG_SYS_HUSH_PARSER 1
+#define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
-#define CFG_LONGHELP /* undef to save memory */
-#ifdef CFG_HUSH_PARSER
-#define CFG_PROMPT "$ " /* Monitor Command Prompt */
+#define CONFIG_SYS_LONGHELP /* undef to save memory */
+#ifdef CONFIG_SYS_HUSH_PARSER
+#define CONFIG_SYS_PROMPT "$ " /* Monitor Command Prompt */
#else
-#define CFG_PROMPT "=> " /* Monitor Command Prompt */
+#define CONFIG_SYS_PROMPT "=> " /* Monitor Command Prompt */
#endif
-#define CFG_CBSIZE 256 /* Console I/O Buffer Size */
-#define CFG_PBSIZE (CFG_CBSIZE+sizeof(CFG_PROMPT)+16) /* Print Buffer Size */
-#define CFG_MAXARGS 16 /* max number of command args */
-#define CFG_BARGSIZE CFG_CBSIZE /* Boot Argument Buffer Size */
-#define CFG_DEVICE_NULLDEV 1
+#define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */
+#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */
+#define CONFIG_SYS_MAXARGS 16 /* max number of command args */
+#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */
+#define CONFIG_SYS_DEVICE_NULLDEV 1
-#define CFG_MEMTEST_START 0xa0400000 /* memtest works on */
-#define CFG_MEMTEST_END 0xa0800000 /* 4 ... 8 MB in DRAM */
+#define CONFIG_SYS_MEMTEST_START 0xa0400000 /* memtest works on */
+#define CONFIG_SYS_MEMTEST_END 0xa0800000 /* 4 ... 8 MB in DRAM */
-#undef CFG_CLKS_IN_HZ /* everything, incl board info, in Hz */
+#undef CONFIG_SYS_CLKS_IN_HZ /* everything, incl board info, in Hz */
-#define CFG_LOAD_ADDR 0xa8000000 /* default load address */
+#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DRAM_BASE + 0x8000) /* default load address */
-#define CFG_HZ 3686400 /* incrementer freq: 3.6864 MHz */
-#define CFG_CPUSPEED 0x161 /* set core clock to 400/200/100 MHz */
+#define CONFIG_SYS_HZ 1000
+#define CONFIG_SYS_CPUSPEED 0x161 /* set core clock to 400/200/100 MHz */
/* valid baudrates */
-#define CFG_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
+#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
-#define CFG_MMC_BASE 0xF0000000
+#define CONFIG_SYS_MMC_BASE 0xF0000000
/*
* Stack sizes
#define PHYS_FLASH_BANK_SIZE 0x02000000 /* 32 MB Banks */
#define PHYS_FLASH_SECT_SIZE 0x00040000 /* 256 KB sectors (x2) */
-#define CFG_DRAM_BASE 0xa0000000
-#define CFG_DRAM_SIZE 0x04000000
+#define CONFIG_SYS_DRAM_BASE 0xa0000000
+#define CONFIG_SYS_DRAM_SIZE 0x04000000
-#define CFG_FLASH_BASE PHYS_FLASH_1
+#define CONFIG_SYS_FLASH_BASE PHYS_FLASH_1
#define FPGA_REGS_BASE_PHYSICAL 0x08000000
/*
* GPIO settings
*/
-#define CFG_GPSR0_VAL 0x00008000
-#define CFG_GPSR1_VAL 0x00FC0382
-#define CFG_GPSR2_VAL 0x0001FFFF
-#define CFG_GPCR0_VAL 0x00000000
-#define CFG_GPCR1_VAL 0x00000000
-#define CFG_GPCR2_VAL 0x00000000
-#define CFG_GPDR0_VAL 0x0060A800
-#define CFG_GPDR1_VAL 0x00FF0382
-#define CFG_GPDR2_VAL 0x0001C000
-#define CFG_GAFR0_L_VAL 0x98400000
-#define CFG_GAFR0_U_VAL 0x00002950
-#define CFG_GAFR1_L_VAL 0x000A9558
-#define CFG_GAFR1_U_VAL 0x0005AAAA
-#define CFG_GAFR2_L_VAL 0xA0000000
-#define CFG_GAFR2_U_VAL 0x00000002
-
-#define CFG_PSSR_VAL 0x20
+#define CONFIG_SYS_GPSR0_VAL 0x00008000
+#define CONFIG_SYS_GPSR1_VAL 0x00FC0382
+#define CONFIG_SYS_GPSR2_VAL 0x0001FFFF
+#define CONFIG_SYS_GPCR0_VAL 0x00000000
+#define CONFIG_SYS_GPCR1_VAL 0x00000000
+#define CONFIG_SYS_GPCR2_VAL 0x00000000
+#define CONFIG_SYS_GPDR0_VAL 0x0060A800
+#define CONFIG_SYS_GPDR1_VAL 0x00FF0382
+#define CONFIG_SYS_GPDR2_VAL 0x0001C000
+#define CONFIG_SYS_GAFR0_L_VAL 0x98400000
+#define CONFIG_SYS_GAFR0_U_VAL 0x00002950
+#define CONFIG_SYS_GAFR1_L_VAL 0x000A9558
+#define CONFIG_SYS_GAFR1_U_VAL 0x0005AAAA
+#define CONFIG_SYS_GAFR2_L_VAL 0xA0000000
+#define CONFIG_SYS_GAFR2_U_VAL 0x00000002
+
+#define CONFIG_SYS_PSSR_VAL 0x20
/*
* Memory settings
*/
-#define CFG_MSC0_VAL 0x23F223F2
-#define CFG_MSC1_VAL 0x3FF1A441
-#define CFG_MSC2_VAL 0x7FF97FF1
-#define CFG_MDCNFG_VAL 0x00001AC9
-#define CFG_MDREFR_VAL 0x00018018
-#define CFG_MDMRS_VAL 0x00000000
+#define CONFIG_SYS_MSC0_VAL 0x23F223F2
+#define CONFIG_SYS_MSC1_VAL 0x3FF1A441
+#define CONFIG_SYS_MSC2_VAL 0x7FF97FF1
+#define CONFIG_SYS_MDCNFG_VAL 0x00001AC9
+#define CONFIG_SYS_MDREFR_VAL 0x00018018
+#define CONFIG_SYS_MDMRS_VAL 0x00000000
/*
* PCMCIA and CF Interfaces
*/
-#define CFG_MECR_VAL 0x00000000
-#define CFG_MCMEM0_VAL 0x00010504
-#define CFG_MCMEM1_VAL 0x00010504
-#define CFG_MCATT0_VAL 0x00010504
-#define CFG_MCATT1_VAL 0x00010504
-#define CFG_MCIO0_VAL 0x00004715
-#define CFG_MCIO1_VAL 0x00004715
+#define CONFIG_SYS_MECR_VAL 0x00000000
+#define CONFIG_SYS_MCMEM0_VAL 0x00010504
+#define CONFIG_SYS_MCMEM1_VAL 0x00010504
+#define CONFIG_SYS_MCATT0_VAL 0x00010504
+#define CONFIG_SYS_MCATT1_VAL 0x00010504
+#define CONFIG_SYS_MCIO0_VAL 0x00004715
+#define CONFIG_SYS_MCIO1_VAL 0x00004715
#define _LED 0x08000010
#define LED_BLANK 0x08000040
/*
* FLASH and environment organization
*/
-#define CFG_MAX_FLASH_BANKS 2 /* max number of memory banks */
-#define CFG_MAX_FLASH_SECT 128 /* max number of sectors on one chip */
+#define CONFIG_SYS_MAX_FLASH_BANKS 2 /* max number of memory banks */
+#define CONFIG_SYS_MAX_FLASH_SECT 128 /* max number of sectors on one chip */
/* timeout values are in ticks */
-#define CFG_FLASH_ERASE_TOUT (25*CFG_HZ) /* Timeout for Flash Erase */
-#define CFG_FLASH_WRITE_TOUT (25*CFG_HZ) /* Timeout for Flash Write */
+#define CONFIG_SYS_FLASH_ERASE_TOUT (25*CONFIG_SYS_HZ) /* Timeout for Flash Erase */
+#define CONFIG_SYS_FLASH_WRITE_TOUT (25*CONFIG_SYS_HZ) /* Timeout for Flash Write */
-/* FIXME */
-#define CFG_ENV_IS_IN_FLASH 1
-#define CFG_ENV_ADDR (PHYS_FLASH_1 + 0x1C000) /* Addr of Environment Sector */
-#define CFG_ENV_SIZE 0x4000 /* Total Size of Environment Sector */
+/* NOTE: many default partitioning schemes assume the kernel starts at the
+ * second sector, not an environment. You have been warned!
+ */
+#define CONFIG_SYS_MONITOR_LEN PHYS_FLASH_SECT_SIZE
+#define CONFIG_ENV_IS_IN_FLASH 1
+#define CONFIG_ENV_ADDR (PHYS_FLASH_1 + PHYS_FLASH_SECT_SIZE)
+#define CONFIG_ENV_SECT_SIZE PHYS_FLASH_SECT_SIZE
+#define CONFIG_ENV_SIZE (PHYS_FLASH_SECT_SIZE / 16)
/*