sh: Fix compile error sh7763rdp board

[oweals/u-boot.git] / include / configs / jupiter.h

diff --git a/include/configs/jupiter.h b/include/configs/jupiter.h
index 4070ab971eb8c3b022a6086270f548131c0d040c..c9859270c00ed0de5666f63a9e06dd88dc559b8e 100644 (file)
--- a/include/configs/jupiter.h
+++ b/include/configs/jupiter.h
@@ -41,6 +41,8 @@
 #define BOOTFLAG_COLD          0x01    /* Normal Power-On: Boot from FLASH  */
 #define BOOTFLAG_WARM          0x02    /* Software reboot           */
 
+#define CONFIG_HIGH_BATS       1       /* High BATs supported */
+
 /*
  * Serial console configuration
  */
@@ -58,6 +60,7 @@
 #if defined(CONFIG_PCI)
 #define CONFIG_PCI_PNP         1
 #define CONFIG_PCI_SCAN_SHOW   1
+#define CONFIG_PCIAUTO_SKIP_HOST_BRIDGE        1
 
 #define CONFIG_PCI_MEM_BUS     0x40000000
 #define CONFIG_PCI_MEM_PHYS    CONFIG_PCI_MEM_BUS
@@ -110,7 +113,7 @@
 #define CONFIG_BOOTDELAY       5       /* autoboot after 5 seconds */
 
 #define CONFIG_PREBOOT "echo;" \
-       "echo Type \"run flash_nfs\" to mount root filesystem over NFS;" \
+       "echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;" \
        "echo"
 
 #undef CONFIG_BOOTARGS
@@ -141,11 +144,11 @@
 /*
  * IPB Bus clocking configuration.
  */
-#undef CFG_IPBSPEED_133        /* define for 133MHz speed */
+#undef CFG_IPBSPEED_133                        /* define for 133MHz speed */
 
 #if 0
 /* pass open firmware flat tree */
-#define CONFIG_OF_FLAT_TREE    1
+#define CONFIG_OF_LIBFDT       1
 #define CONFIG_OF_BOARD_SETUP  1
 
 #define OF_CPU                 "PowerPC,5200@0"