arc: add Arcangel4 board support

[oweals/u-boot.git] / include / configs / cm_t335.h

diff --git a/include/configs/cm_t335.h b/include/configs/cm_t335.h
index e4eba02addf70a8d84c3e2bb2f46ca1f365cc3f1..56e9a8e0e82f01b8d25cf008d8529483e3c35006 100644 (file)
--- a/include/configs/cm_t335.h
+++ b/include/configs/cm_t335.h
@@ -156,5 +156,27 @@
 /* GPIO pin + bank to pin ID mapping */
 #define GPIO_PIN(_bank, _pin)          ((_bank << 5) + _pin)
 
+/* Status LED */
+#define CONFIG_STATUS_LED
+#define CONFIG_GPIO_LED
+#define CONFIG_BOARD_SPECIFIC_LED
+#define STATUS_LED_BIT                 GPIO_PIN(2, 0)
+/* Status LED polarity is inversed, so init it in the "off" state */
+#define STATUS_LED_STATE               STATUS_LED_OFF
+#define STATUS_LED_PERIOD              (CONFIG_SYS_HZ / 2)
+#define STATUS_LED_BOOT                        0
+
+#ifndef CONFIG_SPL_BUILD
+/*
+ * Enable PCA9555 at I2C0-0x26.
+ * First select the I2C0 bus with "i2c dev 0", then use "pca953x" command.
+ */
+#define CONFIG_PCA953X
+#define CONFIG_CMD_PCA953X
+#define CONFIG_CMD_PCA953X_INFO
+#define CONFIG_SYS_I2C_PCA953X_ADDR    0x26
+#define CONFIG_SYS_I2C_PCA953X_WIDTH   { {0x26, 16} }
+#endif /* CONFIG_SPL_BUILD */
+
 #endif /* __CONFIG_CM_T335_H */