#define CONFIG_CMD_PING
#define CONFIG_CMD_NFS
#define CONFIG_CMD_SDRAM
-#define CONFIG_CMD_ENV
+#define CONFIG_CMD_SAVEENV
#define CONFIG_CMD_IDE
#define CONFIG_CMD_EXT2
#define CONFIG_DOS_PARTITION
#define AP325RXA_FLASH_BANK_SIZE (128 * 1024 * 1024)
/* undef to save memory */
-#define CFG_LONGHELP
+#define CONFIG_SYS_LONGHELP
/* Monitor Command Prompt */
-#define CFG_PROMPT "=> "
+#define CONFIG_SYS_PROMPT "=> "
/* Buffer size for input from the Console */
-#define CFG_CBSIZE 256
+#define CONFIG_SYS_CBSIZE 256
/* Buffer size for Console output */
-#define CFG_PBSIZE 256
+#define CONFIG_SYS_PBSIZE 256
/* max args accepted for monitor commands */
-#define CFG_MAXARGS 16
+#define CONFIG_SYS_MAXARGS 16
/* Buffer size for Boot Arguments passed to kernel */
-#define CFG_BARGSIZE 512
+#define CONFIG_SYS_BARGSIZE 512
/* List of legal baudrate settings for this board */
-#define CFG_BAUDRATE_TABLE { 38400 }
+#define CONFIG_SYS_BAUDRATE_TABLE { 38400 }
/* SCIF */
#define CONFIG_SCIF_CONSOLE 1
#define CONFIG_CONS_SCIF5 1
/* Suppress display of console information at boot */
-#undef CFG_CONSOLE_INFO_QUIET
-#undef CFG_CONSOLE_OVERWRITE_ROUTINE
-#undef CFG_CONSOLE_ENV_OVERWRITE
+#undef CONFIG_SYS_CONSOLE_INFO_QUIET
+#undef CONFIG_SYS_CONSOLE_OVERWRITE_ROUTINE
+#undef CONFIG_SYS_CONSOLE_ENV_OVERWRITE
-#define CFG_MEMTEST_START (AP325RXA_SDRAM_BASE)
-#define CFG_MEMTEST_END (CFG_MEMTEST_START + (60 * 1024 * 1024))
+#define CONFIG_SYS_MEMTEST_START (AP325RXA_SDRAM_BASE)
+#define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MEMTEST_START + (60 * 1024 * 1024))
/* Enable alternate, more extensive, memory test */
-#undef CFG_ALT_MEMTEST
+#undef CONFIG_SYS_ALT_MEMTEST
/* Scratch address used by the alternate memory test */
-#undef CFG_MEMTEST_SCRATCH
+#undef CONFIG_SYS_MEMTEST_SCRATCH
/* Enable temporary baudrate change while serial download */
-#undef CFG_LOADS_BAUD_CHANGE
+#undef CONFIG_SYS_LOADS_BAUD_CHANGE
-#define CFG_SDRAM_BASE (AP325RXA_SDRAM_BASE)
+#define CONFIG_SYS_SDRAM_BASE (AP325RXA_SDRAM_BASE)
/* maybe more, but if so u-boot doesn't know about it... */
-#define CFG_SDRAM_SIZE (128 * 1024 * 1024)
+#define CONFIG_SYS_SDRAM_SIZE (128 * 1024 * 1024)
/* default load address for scripts ?!? */
-#define CFG_LOAD_ADDR (CFG_SDRAM_BASE + 16 * 1024 * 1024)
+#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024)
/* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */
-#define CFG_MONITOR_BASE (AP325RXA_FLASH_BASE_1)
+#define CONFIG_SYS_MONITOR_BASE (AP325RXA_FLASH_BASE_1)
/* Monitor size */
-#define CFG_MONITOR_LEN (128 * 1024)
+#define CONFIG_SYS_MONITOR_LEN (128 * 1024)
/* Size of DRAM reserved for malloc() use */
-#define CFG_MALLOC_LEN (256 * 1024)
+#define CONFIG_SYS_MALLOC_LEN (256 * 1024)
/* size in bytes reserved for initial data */
-#define CFG_GBL_DATA_SIZE (256)
-#define CFG_BOOTMAPSZ (8 * 1024 * 1024)
+#define CONFIG_SYS_GBL_DATA_SIZE (256)
+#define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024)
/* FLASH */
#define CONFIG_FLASH_CFI_DRIVER 1
-#define CFG_FLASH_CFI
-#define CFG_FLASH_CFI_DRIVER
-#undef CFG_FLASH_QUIET_TEST
+#define CONFIG_SYS_FLASH_CFI
+#undef CONFIG_SYS_FLASH_QUIET_TEST
/* print 'E' for empty sector on flinfo */
-#define CFG_FLASH_EMPTY_INFO
+#define CONFIG_SYS_FLASH_EMPTY_INFO
/* Physical start address of Flash memory */
-#define CFG_FLASH_BASE (AP325RXA_FLASH_BASE_1)
+#define CONFIG_SYS_FLASH_BASE (AP325RXA_FLASH_BASE_1)
/* Max number of sectors on each Flash chip */
-#define CFG_MAX_FLASH_SECT 512
+#define CONFIG_SYS_MAX_FLASH_SECT 512
/*
* IDE support
*/
#define CONFIG_IDE_RESET 1
-#define CFG_PIO_MODE 1
-#define CFG_IDE_MAXBUS 1 /* IDE bus */
-#define CFG_IDE_MAXDEVICE 1
-#define CFG_ATA_BASE_ADDR 0xB4180000
-#define CFG_ATA_STRIDE 2 /* 1bit shift */
-#define CFG_ATA_DATA_OFFSET 0x200 /* data reg offset */
-#define CFG_ATA_REG_OFFSET 0x200 /* reg offset */
-#define CFG_ATA_ALT_OFFSET 0x210 /* alternate register offset */
+#define CONFIG_SYS_PIO_MODE 1
+#define CONFIG_SYS_IDE_MAXBUS 1 /* IDE bus */
+#define CONFIG_SYS_IDE_MAXDEVICE 1
+#define CONFIG_SYS_ATA_BASE_ADDR 0xB4180000
+#define CONFIG_SYS_ATA_STRIDE 2 /* 1bit shift */
+#define CONFIG_SYS_ATA_DATA_OFFSET 0x200 /* data reg offset */
+#define CONFIG_SYS_ATA_REG_OFFSET 0x200 /* reg offset */
+#define CONFIG_SYS_ATA_ALT_OFFSET 0x210 /* alternate register offset */
/* if you use all NOR Flash , you change dip-switch. Please see Manual. */
-#define CFG_MAX_FLASH_BANKS 1
-#define CFG_FLASH_BANKS_LIST { CFG_FLASH_BASE + (0 * AP325RXA_FLASH_BANK_SIZE)}
+#define CONFIG_SYS_MAX_FLASH_BANKS 1
+#define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE + (0 * AP325RXA_FLASH_BANK_SIZE)}
/* Timeout for Flash erase operations (in ms) */
-#define CFG_FLASH_ERASE_TOUT (3 * 1000)
+#define CONFIG_SYS_FLASH_ERASE_TOUT (3 * 1000)
/* Timeout for Flash write operations (in ms) */
-#define CFG_FLASH_WRITE_TOUT (3 * 1000)
+#define CONFIG_SYS_FLASH_WRITE_TOUT (3 * 1000)
/* Timeout for Flash set sector lock bit operations (in ms) */
-#define CFG_FLASH_LOCK_TOUT (3 * 1000)
+#define CONFIG_SYS_FLASH_LOCK_TOUT (3 * 1000)
/* Timeout for Flash clear lock bit operations (in ms) */
-#define CFG_FLASH_UNLOCK_TOUT (3 * 1000)
+#define CONFIG_SYS_FLASH_UNLOCK_TOUT (3 * 1000)
/*
* Use hardware flash sectors protection instead
* of U-Boot software protection
*/
-#undef CFG_FLASH_PROTECTION
-#undef CFG_DIRECT_FLASH_TFTP
+#undef CONFIG_SYS_FLASH_PROTECTION
+#undef CONFIG_SYS_DIRECT_FLASH_TFTP
/* ENV setting */
-#define CFG_ENV_IS_IN_FLASH
+#define CONFIG_ENV_IS_IN_FLASH
#define CONFIG_ENV_OVERWRITE 1
-#define CFG_ENV_SECT_SIZE (128 * 1024)
-#define CFG_ENV_SIZE (CFG_ENV_SECT_SIZE)
-#define CFG_ENV_ADDR (CFG_FLASH_BASE + CFG_MONITOR_LEN)
-/* Offset of env Flash sector relative to CFG_FLASH_BASE */
-#define CFG_ENV_OFFSET (CFG_ENV_ADDR - CFG_FLASH_BASE)
-#define CFG_ENV_SIZE_REDUND (CFG_ENV_SECT_SIZE)
+#define CONFIG_ENV_SECT_SIZE (128 * 1024)
+#define CONFIG_ENV_SIZE (CONFIG_ENV_SECT_SIZE)
+#define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN)
+/* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */
+#define CONFIG_ENV_OFFSET (CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE)
+#define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SECT_SIZE)
/* Board Clock */
#define CONFIG_SYS_CLK_FREQ 33333333
#define TMU_CLK_DIVIDER (4) /* 4 (default), 16, 64, 256 or 1024 */
-#define CFG_HZ (CONFIG_SYS_CLK_FREQ / TMU_CLK_DIVIDER)
+#define CONFIG_SYS_HZ (CONFIG_SYS_CLK_FREQ / TMU_CLK_DIVIDER)
#endif /* __AP325RXA_H */