#define CONFIG_BAUDRATE 115200
#endif
-#define CONFIG_PREBOOT "echo;echo Type \"run flash_nfs\" to mount root filesystem over NFS;echo"
+#define CONFIG_PREBOOT "echo;echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;echo"
#undef CONFIG_BOOTARGS
"cp.b 300000 40000000 40000;" \
"setenv filesize;saveenv\0" \
"cphwib=cp.b 4003fc00 33fc00 400\0" \
- "upd=run load;run cphwib;run update\0" \
+ "upd=run load cphwib update\0" \
""
#define CONFIG_BOOTCOMMAND "run flash_self"
/* enable I2C and select the hardware/software driver */
#undef CONFIG_HARD_I2C /* I2C with hardware support */
#define CONFIG_SOFT_I2C 1 /* I2C bit-banged */
-#define ADD_CMD_I2C CFG_CMD_I2C | \
- CFG_CMD_DATE |\
- CFG_CMD_DTT |\
- CFG_CMD_EEPROM
#define CFG_I2C_SPEED 400000 /* I2C speed and slave address */
#define CFG_I2C_SLAVE 0x7F
#else
#undef CONFIG_HARD_I2C
#undef CONFIG_SOFT_I2C
-#define ADD_CMD_I2C 0
#endif
/*
* for FCC)
*
* if CONFIG_ETHER_NONE is defined, then either the ethernet routines must be
- * defined elsewhere (as for the console), or CFG_CMD_NET must be removed
- * from CONFIG_COMMANDS to remove support for networking.
+ * defined elsewhere (as for the console), or CONFIG_CMD_NET must be unset.
*
* (On TQM8272 either SCC1 or FCC2 may be chosen: SCC1 is hardwired to the
* X.29 connector, and FCC2 is hardwired to the X.1 connector)
#define CONFIG_TIMESTAMP /* Print image info with timestamp */
-#define CONFIG_BOOTP_MASK (CONFIG_BOOTP_DEFAULT|CONFIG_BOOTP_BOOTFILESIZE)
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_SUBNETMASK
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_BOOTFILESIZE
/*
#define CONFIG_CMD_PING
#define CONFIG_CMD_SNTP
+#if CONFIG_I2C
+ #define CONFIG_CMD_I2C
+ #define CONFIG_CMD_DATE
+ #define CONFIG_CMD_DTT
+ #define CONFIG_CMD_EEPROM
+#endif
+
/*
* Miscellaneous configurable options
#define CFG_MAX_FLASH_SECT 128 /* max num of sects on one chip */
#define CFG_FLASH_CFI /* flash is CFI compat. */
-#define CFG_FLASH_CFI_DRIVER /* Use common CFI driver*/
+#define CONFIG_FLASH_CFI_DRIVER /* Use common CFI driver*/
#define CFG_FLASH_EMPTY_INFO /* print 'E' for empty sector */
#define CFG_FLASH_QUIET_TEST 1 /* don't warn upon unknown flash*/
WRITE_NAND(d, addr); \
} while(0)
-#endif /* CFG_CMD_NAND */
+#endif /* CONFIG_CMD_NAND */
#define CONFIG_PCI
#ifdef CONFIG_PCI