#define CONFIG_ARM7 1 /* This is a ARM7 CPU */
#define CONFIG_ARM_THUMB 1 /* this is an ARM720TDMI */
#define CONFIG_LPC2292
-#undef CONFIG_ARM7_REVD /* disable ARM720 REV.D Workarounds */
+#undef CONFIG_ARM7_REVD /* disable ARM720 REV.D Workarounds */
#undef CONFIG_USE_IRQ /* don't need them anymore */
/*
* Size of malloc() pool
*/
-#define CFG_MALLOC_LEN (CFG_ENV_SIZE + 128*1024)
-#define CFG_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
+#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024)
+#define CONFIG_SYS_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
/*
* Hardware drivers
/*
* select serial console configuration
*/
+#define CONFIG_LPC2292_SERIAL
#define CONFIG_SERIAL1 1 /* we use Serial line 1 */
/* allow to overwrite serial and ethaddr */
#define CONFIG_BAUDRATE 115200
-#define CONFIG_BOOTP_MASK (CONFIG_BOOTP_DEFAULT|CONFIG_BOOTP_BOOTFILESIZE)
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_SUBNETMASK
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_BOOTFILESIZE
+
/* enable I2C and select the hardware/software driver */
-#undef CONFIG_HARD_I2C /* I2C with hardware support */
+#undef CONFIG_HARD_I2C /* I2C with hardware support */
#define CONFIG_SOFT_I2C 1 /* I2C bit-banged */
/* this would be 0xAE if E0, E1 and E2 were pulled high */
-#define CFG_I2C_SLAVE 0xA0
-#define CFG_I2C_EEPROM_ADDR (0xA0 >> 1)
-#define CFG_I2C_EEPROM_ADDR_LEN 2 /* 16 bit address */
-#define CFG_EEPROM_PAGE_WRITE_BITS 6 /* 64 bytes per write */
-#define CFG_EEPROM_PAGE_WRITE_DELAY_MS 20
+#define CONFIG_SYS_I2C_SLAVE 0xA0
+#define CONFIG_SYS_I2C_EEPROM_ADDR (0xA0 >> 1)
+#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 2 /* 16 bit address */
+#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 6 /* 64 bytes per write */
+#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 20
/* not used but required by devices.c */
-#define CFG_I2C_SPEED 10000
+#define CONFIG_SYS_I2C_SPEED 10000
#ifdef CONFIG_SOFT_I2C
/*
#define I2C_SCL(x) { if (x) PUT32(IO0SET, SCL); else PUT32(IO0CLR, SCL); }
#define I2C_DELAY { udelay(100); }
#define I2C_ACTIVE { unsigned int i2ctmp; \
- i2ctmp = GET32(IO0DIR); \
+ i2ctmp = GET32(IO0DIR); \
i2ctmp |= SDA; \
PUT32(IO0DIR, i2ctmp); }
#define I2C_TRISTATE { unsigned int i2ctmp; \
- i2ctmp = GET32(IO0DIR); \
+ i2ctmp = GET32(IO0DIR); \
i2ctmp &= ~SDA; \
PUT32(IO0DIR, i2ctmp); }
#endif /* CONFIG_SOFT_I2C */
+
/*
- * Supported commands
+ * Command line configuration.
*/
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL | \
- CFG_CMD_DHCP | \
- CFG_CMD_FAT | \
- CFG_CMD_MMC | \
- CFG_CMD_NET | \
- CFG_CMD_EEPROM | \
- CFG_CMD_PING)
+#include <config_cmd_default.h>
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_FAT
+#define CONFIG_CMD_MMC
+#define CONFIG_CMD_NET
+#define CONFIG_CMD_EEPROM
+#define CONFIG_CMD_PING
-#define CONFIG_DOS_PARTITION
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
+#define CONFIG_DOS_PARTITION
#define CONFIG_BOOTDELAY 5
/*
* Miscellaneous configurable options
*/
-#define CFG_LONGHELP /* undef to save memory */
-#define CFG_PROMPT "SMN42 # " /* Monitor Command Prompt */
-#define CFG_CBSIZE 256 /* Console I/O Buffer Size */
-#define CFG_PBSIZE (CFG_CBSIZE+sizeof(CFG_PROMPT)+16) /* Print Buffer Size */
-#define CFG_MAXARGS 16 /* max number of command args */
-#define CFG_BARGSIZE CFG_CBSIZE /* Boot Argument Buffer Size */
-
-#define CFG_MEMTEST_START 0x81800000 /* memtest works on */
-#define CFG_MEMTEST_END 0x83000000 /* 24 MB in SRAM */
+#define CONFIG_SYS_LONGHELP /* undef to save memory */
+#define CONFIG_SYS_PROMPT "SMN42 # " /* Monitor Command Prompt */
+#define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */
+#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */
+#define CONFIG_SYS_MAXARGS 16 /* max number of command args */
+#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */
-#undef CFG_CLKS_IN_HZ /* everything, incl board info, in Hz */
+#define CONFIG_SYS_MEMTEST_START 0x81800000 /* memtest works on */
+#define CONFIG_SYS_MEMTEST_END 0x83000000 /* 24 MB in SRAM */
-#define CFG_LOAD_ADDR 0x81000000 /* default load address
- * for uClinux img is here*/
+#define CONFIG_SYS_LOAD_ADDR 0x81000000 /* default load address */
+ /* for uClinux img is here*/
-#define CFG_SYS_CLK_FREQ 58982400 /* Hz */
-#define CFG_HZ 2048 /* decrementer freq in Hz */
+#define CONFIG_SYS_SYS_CLK_FREQ 58982400 /* Hz */
+#define CONFIG_SYS_HZ 2048 /* decrementer freq in Hz */
/* valid baudrates */
-#define CFG_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
+#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
/*-----------------------------------------------------------------------
* Stack sizes
*/
/*
- * The first entry in CFG_FLASH_BANKS_LIST is a dummy, but it must be present.
+ * The first entry in CONFIG_SYS_FLASH_BANKS_LIST is a dummy, but it must be present.
*/
-#define CFG_FLASH_BANKS_LIST { 0, PHYS_FLASH_1 }
-#define CFG_FLASH_ADDR0 0x555
-#define CFG_FLASH_ADDR1 0x2AA
-#define CFG_FLASH_ERASE_TOUT 16384 /* Timeout for Flash Erase (in ms) */
-#define CFG_FLASH_WRITE_TOUT 5 /* Timeout for Flash Write (in ms) */
+#define CONFIG_SYS_FLASH_BANKS_LIST { 0, PHYS_FLASH_1 }
+#define CONFIG_SYS_FLASH_ADDR0 0x555
+#define CONFIG_SYS_FLASH_ADDR1 0x2AA
+#define CONFIG_SYS_FLASH_ERASE_TOUT 16384 /* Timeout for Flash Erase (in ms) */
+#define CONFIG_SYS_FLASH_WRITE_TOUT 5 /* Timeout for Flash Write (in ms) */
-#define CFG_MAX_FLASH_SECT 128 /* max number of sectors on one chip */
+#define CONFIG_SYS_MAX_FLASH_SECT 128 /* max number of sectors on one chip */
-#define CFG_MAX_FLASH_BANKS 2 /* max number of memory banks */
+#define CONFIG_SYS_MAX_FLASH_BANKS 2 /* max number of memory banks */
-#define CFG_ENV_IS_IN_FLASH 1
+#define CONFIG_ENV_IS_IN_FLASH 1
/* The Environment Sector is in the CPU-internal flash */
-#define CFG_FLASH_BASE 0
-#define CFG_ENV_OFFSET 0x3C000
-#define CFG_ENV_ADDR (CFG_FLASH_BASE + CFG_ENV_OFFSET)
-#define CFG_ENV_SIZE 0x2000 /* Total Size of Environment Sector */
+#define CONFIG_SYS_FLASH_BASE 0
+#define CONFIG_ENV_OFFSET 0x3C000
+#define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + CONFIG_ENV_OFFSET)
+#define CONFIG_ENV_SIZE 0x2000 /* Total Size of Environment Sector */
#define CONFIG_CMDLINE_TAG
#define CONFIG_SETUP_MEMORY_TAGS