NAND finally working. Two bugs fixed:

[oweals/u-boot.git] / include / configs / SBC8560.h

diff --git a/include/configs/SBC8560.h b/include/configs/SBC8560.h
index 8e3c3923d323f71d92b8fc2f0e550dd4bd2f5512..8b46a17ed58779db1e4e3cb5a0dabb0a45ab7f77 100644 (file)
--- a/include/configs/SBC8560.h
+++ b/include/configs/SBC8560.h
@@ -46,7 +46,7 @@
 #define CONFIG_MPC85xx_REV1    1       /* MPC85xx Rev 1.0 chip         */
 
 
-#define CONFIG_MPC8560         1       /* MPC8560 (CPU) specific               */
+#define CONFIG_CPM2            1       /* has CPM2 */
 #define CONFIG_SBC8560         1       /* configuration for SBC8560 board */
 
 #define CONFIG_MPC8560ADS      1       /* MPC8560ADS board specific (supplement)       */
@@ -215,10 +215,14 @@
 
 #if defined(CONFIG_TSEC_ENET)          /* TSEC Ethernet port */
 
-  #define CONFIG_NET_MULTI     1
-  #define CONFIG_PHY_BCM5421S          /* GigaBit Ether PHY         */
-  #define CONFIG_MII           1       /* MII PHY management           */
-  #define CONFIG_PHY_ADDR      25      /* PHY address                  */
+#  define CONFIG_NET_MULTI     1
+#  define CONFIG_MII           1       /* MII PHY management           */
+#  define CONFIG_MPC85xx_TSEC1
+#  define CONFIG_MPC85xx_TSEC1_NAME    "TSEC0"
+#  define TSEC1_PHY_ADDR       25
+#  define TSEC1_PHYIDX         0
+/* Options are: TSEC0 */
+#  define CONFIG_ETHPRIME              "TSEC0"
 
 
 #elif defined(CONFIG_ETHER_ON_FCC)     /* CPM FCC Ethernet */
@@ -388,9 +392,11 @@
 
 /*Note: change below for your network setting!!! */
 #if defined(CONFIG_TSEC_ENET) || defined(CONFIG_ETHER_ON_FCC)
-  #define CONFIG_ETHADDR       00:vv:ww:xx:yy:8a
-  #define CONFIG_ETH1ADDR      00:vv:ww:xx:yy:8b
-  #define CONFIG_ETH2ADDR      00:vv:ww:xx:yy:8c
+#  define CONFIG_ETHADDR       00:vv:ww:xx:yy:8a
+#  define CONFIG_HAS_ETH1
+#  define CONFIG_ETH1ADDR      00:vv:ww:xx:yy:8b
+#  define CONFIG_HAS_ETH2
+#  define CONFIG_ETH2ADDR      00:vv:ww:xx:yy:8c
 #endif
 
 #define CONFIG_SERVERIP                YourServerIP