#ifndef __CONFIG_H
#define __CONFIG_H
-#include <asm/processor.h>
-
#ifndef __ASSEMBLY__
#include <galileo/core.h>
#endif
#define CONFIG_P3G4 1 /* this is a P3G4 board */
#define CFG_GT_6426x GT_64260 /* with a 64260 system controller */
-#define CONFIG_BAUDRATE 115200 /* console baudrate = 115200 */
+#define CONFIG_BAUDRATE 115200 /* console baudrate = 115200 */
#undef CONFIG_ECC /* enable ECC support */
/* #define CONFIG_EVB64260_750CX 1 */ /* Support the EVB-64260-750CX Board */
/* which initialization functions to call for this board */
#define CONFIG_MISC_INIT_R 1
-#define CONFIG_BOARD_PRE_INIT 1
+#define CONFIG_BOARD_EARLY_INIT_F 1
#define CFG_BOARD_NAME "P3G4"
* mpsc channel, change CONFIG_MPSC_PORT to the desired value.
*/
#define CONFIG_MPSC
-#define CONFIG_MPSC_PORT 1
+#define CONFIG_MPSC_PORT 0
#define CONFIG_NET_MULTI /* attempt all available adapters */
#undef CONFIG_ETHER_PORT_MII /* use RMII */
-#if 1
+#if 0
#define CONFIG_BOOTDELAY -1 /* autoboot disabled */
#else
#define CONFIG_BOOTDELAY 5 /* autoboot after 5 seconds */
#endif
#define CONFIG_ZERO_BOOTDELAY_CHECK
+#define CONFIG_PREBOOT "echo;" \
+ "echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;" \
+ "echo"
+
#undef CONFIG_BOOTARGS
-#define CONFIG_BOOTCOMMAND \
- "bootp && " \
- "setenv bootargs root=/dev/nfs rw nfsroot=$serverip:$rootpath " \
- "ip=$ipaddr:$serverip:$gatewayip:" \
- "$netmask:$hostname:eth0:none; && " \
- "bootm"
+
+#define CONFIG_EXTRA_ENV_SETTINGS \
+ "netdev=eth0\0" \
+ "hostname=p3g4\0" \
+ "nfsargs=setenv bootargs root=/dev/nfs rw " \
+ "nfsroot=${serverip}:${rootpath}\0" \
+ "ramargs=setenv bootargs root=/dev/ram rw\0" \
+ "addip=setenv bootargs ${bootargs} " \
+ "ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}" \
+ ":${hostname}:${netdev}:off panic=1\0" \
+ "addtty=setenv bootargs ${bootargs} console=ttyS0,${baudrate}\0"\
+ "flash_nfs=run nfsargs addip addtty;" \
+ "bootm ${kernel_addr}\0" \
+ "flash_self=run ramargs addip addtty;" \
+ "bootm ${kernel_addr} ${ramdisk_addr}\0" \
+ "net_nfs=tftp 200000 ${bootfile};run nfsargs addip addtty;" \
+ "bootm\0" \
+ "rootpath=/opt/eldk/ppc_74xx\0" \
+ "bootfile=/tftpboot/p3g4/uImage\0" \
+ "kernel_addr=ff000000\0" \
+ "ramdisk_addr=ff010000\0" \
+ "load=tftp 100000 /tftpboot/p3g4/u-boot.bin\0" \
+ "update=protect off fff00000 fff3ffff;era fff00000 fff3ffff;" \
+ "cp.b 100000 fff00000 ${filesize};" \
+ "setenv filesize;saveenv\0" \
+ "upd=run load update\0" \
+ ""
+#define CONFIG_BOOTCOMMAND "run flash_self"
#define CONFIG_LOADS_ECHO 0 /* echo off for serial download */
#define CFG_LOADS_BAUD_CHANGE /* allow baudrate changes */
#undef CONFIG_WATCHDOG /* watchdog disabled */
#undef CONFIG_ALTIVEC /* undef to disable */
-#define CONFIG_BOOTP_MASK (CONFIG_BOOTP_DEFAULT | \
- CONFIG_BOOTP_BOOTFILESIZE)
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_SUBNETMASK
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_BOOTFILESIZE
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL | CFG_CMD_ASKENV)
+#define CONFIG_TIMESTAMP /* Print image info with timestamp */
+
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
+
+#define CONFIG_CMD_ASKENV
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_PCI
+#define CONFIG_CMD_ELF
+#define CONFIG_CMD_MII
+#define CONFIG_CMD_PING
+#define CONFIG_CMD_UNIVERSE
+#define CONFIG_CMD_BSP
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
/*
* Miscellaneous configurable options
*/
#define CFG_LONGHELP /* undef to save memory */
#define CFG_PROMPT "=> " /* Monitor Command Prompt */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CFG_CBSIZE 1024 /* Console I/O Buffer Size */
#else
#define CFG_CBSIZE 256 /* Console I/O Buffer Size */
* Please note that CFG_SDRAM_BASE _must_ start at 0
*/
#define CFG_SDRAM_BASE 0x00000000
-#define CFG_FLASH_BASE 0xff800000
+#define CFG_FLASH_BASE 0xff000000
#define CFG_RESET_ADDRESS 0xfff00100
#define CFG_MONITOR_LEN (256 << 10) /* Reserve 256 kB for Monitor */
#define CFG_MONITOR_BASE TEXT_BASE
/* PCI MEMORY MAP section */
#define CFG_PCI0_MEM_BASE 0x80000000
#define CFG_PCI0_MEM_SIZE _128M
+#define CFG_PCI0_0_MEM_SPACE (CFG_PCI0_MEM_BASE)
+
#define CFG_PCI1_MEM_BASE 0x88000000
#define CFG_PCI1_MEM_SIZE _128M
-
-#define CFG_PCI0_0_MEM_SPACE (CFG_PCI0_MEM_BASE)
#define CFG_PCI1_0_MEM_SPACE (CFG_PCI1_MEM_BASE)
-
/* PCI I/O MAP section */
#define CFG_PCI0_IO_BASE 0xfa000000
#define CFG_PCI0_IO_SIZE _16M
-#define CFG_PCI1_IO_BASE 0xfb000000
-#define CFG_PCI1_IO_SIZE _16M
-
#define CFG_PCI0_IO_SPACE (CFG_PCI0_IO_BASE)
#define CFG_PCI0_IO_SPACE_PCI 0x00000000
+
+#define CFG_PCI1_IO_BASE 0xfb000000
+#define CFG_PCI1_IO_SIZE _16M
#define CFG_PCI1_IO_SPACE (CFG_PCI1_IO_BASE)
#define CFG_PCI1_IO_SPACE_PCI 0x00000000
#define CFG_MAX_FLASH_BANKS 2 /* max number of memory banks */
#define CFG_MAX_FLASH_SECT 67 /* max number of sectors on one chip */
-#define CFG_EXTRA_FLASH_DEVICE DEVICE0 /* extra flash at device 0 */
+#define CFG_EXTRA_FLASH_DEVICE BOOT_DEVICE
#define CFG_EXTRA_FLASH_WIDTH 2 /* 16 bit */
#define CFG_BOOT_FLASH_WIDTH 2 /* 16 bit */
* Cache Configuration
*/
#define CFG_CACHELINE_SIZE 32 /* For all MPC74xx CPUs */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CFG_CACHELINE_SHIFT 5 /* log base 2 of the above value */
#endif
#define CFG_L2
-#define L2_INIT (L2CR_L2SIZ_2M | L2CR_L2CLK_3 | L2CR_L2RAM_BURST | \
- L2CR_L2OH_5 | L2CR_L2CTL | L2CR_L2WT)
+#define L2_INIT (L2CR_L2SIZ_2M | L2CR_L2CLK_3 | L2CR_L2RAM_BURST | \
+ L2CR_L2OH_5 | L2CR_L2CTL | L2CR_L2WT)
#define L2_ENABLE (L2_INIT | L2CR_L2E)