#define CFG_MEMTEST_START 0x00200000 /* memtest region */
#define CFG_MEMTEST_END 0x00400000
-
/*
* Base addresses -- Note these are effective addresses where the
* actual resources get mapped (not physical addresses)
#define CFG_CCSRBAR 0xf8000000 /* relocated CCSRBAR */
#define CFG_IMMR CFG_CCSRBAR /* PQII uses CFG_IMMR */
-
/*
* DDR Setup
*/
/*
* I2C
*/
-#define CONFIG_HARD_I2C /* I2C with hardware support*/
+#define CONFIG_FSL_I2C /* Use FSL common I2C driver */
+#define CONFIG_HARD_I2C /* I2C with hardware support*/
#undef CONFIG_SOFT_I2C /* I2C bit-banged */
#define CFG_I2C_SPEED 400000 /* I2C speed and slave address */
#define CFG_I2C_SLAVE 0x7F
#define CFG_I2C_NOPROBES {0x69} /* Don't probe these addrs */
+#define CFG_I2C_OFFSET 0x3100
/*
* RapidIO MMU
#define CFG_PCI2_IO_PHYS CFG_PCI2_IO_BASE
#define CFG_PCI2_IO_SIZE 0x1000000 /* 16M */
-
#if defined(CONFIG_PCI)
#define CONFIG_PCI_SCAN_SHOW /* show pci devices on startup */
#endif /* CONFIG_PCI */
-
#if defined(CONFIG_TSEC_ENET)
#ifndef CONFIG_NET_MULTI
#endif /* CONFIG_TSEC_ENET */
-
/*
* BAT0 2G Cacheable, non-guarded
* 0x0000_0000 2G DDR
#define CFG_IBAT7L 0x00000000
#define CFG_IBAT7U 0x00000000
-
-
-
/*
* Environment
*/
#define CONFIG_KGDB_SER_INDEX 2 /* which serial port to use */
#endif
-
/*
* Environment Configuration
*/
#define CONFIG_EXTRA_ENV_SETTINGS \
"netdev=eth0\0" \
"consoledev=ttyS0\0" \
- "ramdiskaddr=400000\0" \
+ "ramdiskaddr=2000000\0" \
"ramdiskfile=your.ramdisk.u-boot\0" \
- "dtbaddr=2000000\0" \
+ "dtbaddr=400000\0" \
"dtbfile=mpc8641_hpcn.dtb\0" \
- "pex0=echo ---------------------------; echo --------- PCI EXPRESS -----\0"\
- "pexstat=mw f8008000 84000004; echo -expect:- 16000000; md f8008004 1\0" \
- "pex1=pci write 1.0.0 4 146; pci write 1.0.0 10 80000000\0" \
- "pexd=echo -expect:- xxx01002 00100146; pci display 1.0.0 0 2\0" \
- "pex=run pexstat; run pex1; run pexd\0" \
"en-wd=mw.b f8100010 0x08; echo -expect:- 08; md.b f8100010 1\0" \
"dis-wd=mw.b f8100010 0x00; echo -expect:- 00; md.b f8100010 1\0" \
"maxcpus=2"