#ifndef __CONFIG_H
#define __CONFIG_H
-#include <asm/processor.h>
-
/* This define must be before the core.h include */
#define CONFIG_DB64360 1 /* this is an DB64360 board */
/* first ethernet */
#define CONFIG_ETHADDR 64:36:00:00:00:01
/* next two ethernet hwaddrs */
+#define CONFIG_HAS_ETH1
#define CONFIG_ETH1ADDR 64:36:00:00:00:02
/* in the atlantis 64360 we have only 2 ETH port on the board,
if we use PCI it has its own MAC addr */
#undef CONFIG_BOOTARGS
-/*#define CONFIG_PREBOOT "echo;echo Type \"run flash_nfs\" to mount root filesystem over NFS;echo" */
+/*#define CONFIG_PREBOOT "echo;echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;echo" */
/* ronen - autoboot using tftp */
#if (CONFIG_BOOTDELAY >= 0)
#define CONFIG_BOOTCOMMAND "tftpboot 0x400000 uImage;\
- setenv bootargs $(bootargs) $(bootargs_root) nfsroot=$(serverip):$(rootpath) \
- ip=$(ipaddr):$(serverip)$(bootargs_end); bootm 0x400000; "
+ setenv bootargs ${bootargs} ${bootargs_root} nfsroot=${serverip}:${rootpath} \
+ ip=${ipaddr}:${serverip}${bootargs_end}; bootm 0x400000; "
#define CONFIG_BOOTARGS "console=ttyS0,115200"
"bootargs_root=root=/dev/nfs rw\0" \
"bootargs_end=:::DB64360:eth0:none \0"\
"ethprime=mv_enet0\0"\
- "standalone=fsload 0x400000 uImage;setenv bootargs $(bootargs) root=/dev/mtdblock/0 rw \
-ip=$(ipaddr):$(serverip)$(bootargs_end); bootm 0x400000;\0"
+ "standalone=fsload 0x400000 uImage;setenv bootargs ${bootargs} root=/dev/mtdblock/0 rw \
+ip=${ipaddr}:${serverip}${bootargs_end}; bootm 0x400000;\0"
/* --------------------------------------------------------------------------------------------------------------- */
/* New bootcommands for Marvell DB64360 c 2002 Ingo Assmus */
#undef CONFIG_WATCHDOG /* watchdog disabled */
#undef CONFIG_ALTIVEC /* undef to disable */
-#define CONFIG_BOOTP_MASK (CONFIG_BOOTP_DEFAULT | \
- CONFIG_BOOTP_BOOTFILESIZE)
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_SUBNETMASK
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_BOOTFILESIZE
+
+
+/*
+ * JFFS2 partitions
+ *
+ */
+/* No command line, one static partition, whole device */
+#undef CONFIG_JFFS2_CMDLINE
+#define CONFIG_JFFS2_DEV "nor1"
+#define CONFIG_JFFS2_PART_SIZE 0xFFFFFFFF
+#define CONFIG_JFFS2_PART_OFFSET 0x00000000
+
+/* mtdparts command line support */
-/* Flash banks JFFS2 should use */
-#define CFG_JFFS2_FIRST_BANK 1
-#define CFG_JFFS2_NUM_BANKS 1
+/* Use first bank for JFFS2, second bank contains U-Boot.
+ *
+ * Note: fake mtd_id's used, no linux mtd map file.
+ */
+/*
+#define CONFIG_JFFS2_CMDLINE
+#define MTDIDS_DEFAULT "nor1=db64360-1"
+#define MTDPARTS_DEFAULT "mtdparts=db64360-1:-(jffs2)"
+*/
+
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL \
- | CFG_CMD_ASKENV \
- | CFG_CMD_I2C \
- | CFG_CMD_EEPROM \
- | CFG_CMD_CACHE \
- | CFG_CMD_JFFS2 \
- | CFG_CMD_PCI \
- | CFG_CMD_NET )
+#define CONFIG_CMD_ASKENV
+#define CONFIG_CMD_I2C
+#define CONFIG_CMD_EEPROM
+#define CONFIG_CMD_CACHE
+#define CONFIG_CMD_JFFS2
+#define CONFIG_CMD_PCI
+#define CONFIG_CMD_NET
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
/*
* Miscellaneous configurable options
/* #define CFG_GT_DUAL_CPU also for JTAG even with one cpu */
#define CFG_LONGHELP /* undef to save memory */
#define CFG_PROMPT "=> " /* Monitor Command Prompt */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CFG_CBSIZE 1024 /* Console I/O Buffer Size */
#else
#define CFG_CBSIZE 256 /* Console I/O Buffer Size */
* Cache Configuration
*/
#define CFG_CACHELINE_SIZE 32 /* For all MPC74xx CPUs */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CFG_CACHELINE_SHIFT 5 /* log base 2 of the above value */
#endif