#ifndef __ASSEMBLY__ /* put C only stuff in this section */
-typedef unsigned char uchar;
typedef volatile unsigned long vu_long;
typedef volatile unsigned short vu_short;
typedef volatile unsigned char vu_char;
extern u8 __dtb_dt_spl_begin[]; /* embedded device tree blob for SPL/TPL */
int mdm_init(void);
-/**
- * Show the DRAM size in a board-specific way
- *
- * This is used by boards to display DRAM information in their own way.
- *
- * @param size Size of DRAM (which should be displayed along with other info)
- */
-void board_show_dram(phys_size_t size);
-
-/**
- * Get the uppermost pointer that is valid to access
- *
- * Some systems may not map all of their address space. This function allows
- * boards to indicate what their highest support pointer value is for DRAM
- * access.
- *
- * @param total_size Size of U-Boot (unused?)
- */
-ulong board_get_usable_ram_top(ulong total_size);
-
/**
* arch_fixup_fdt() - Write arch-specific information to fdt
*
/* common/cmd_ext2.c */
int do_ext2load(cmd_tbl_t *, int, int, char * const []);
-void pci_init_board(void);
-
/* common/exports.c */
void jumptable_init(void);
void reset_phy (void);
void fdc_hw_init (void);
-/* $(BOARD)/eeprom.c */
-#ifdef CONFIG_CMD_EEPROM
-void eeprom_init (int bus);
-int eeprom_read (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cnt);
-int eeprom_write (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cnt);
-#else
-/*
- * Some EEPROM code is depecated because it used the legacy I2C interface. Add
- * some macros here so we don't have to touch every one of those uses
- */
-#define eeprom_init(bus)
-#define eeprom_read(dev_addr, offset, buffer, cnt) ((void)-ENOSYS)
-#define eeprom_write(dev_addr, offset, buffer, cnt) ((void)-ENOSYS)
-#endif
-
#if !defined(CONFIG_ENV_EEPROM_IS_ON_I2C) && defined(CONFIG_SYS_I2C_EEPROM_ADDR)
# define CONFIG_SYS_DEF_EEPROM_ADDR CONFIG_SYS_I2C_EEPROM_ADDR
#endif
-/* $(BOARD)/$(BOARD).c */
-int board_early_init_f (void);
-int board_fix_fdt (void *rw_fdt_blob); /* manipulate the U-Boot fdt before its relocation */
-int board_late_init (void);
-int board_postclk_init (void); /* after clocks/timebase, before env/serial */
-int board_early_init_r (void);
-
#if defined(CONFIG_SYS_DRAM_TEST)
int testdram(void);
#endif /* CONFIG_SYS_DRAM_TEST */
#else
void relocate_code(ulong, gd_t *, ulong) __attribute__ ((noreturn));
#endif
-ulong get_endaddr (void);
-void trap_init (ulong);
void s_init(void);