if DM_SPI
+config SPI_MEM
+ bool "SPI memory extension"
+ help
+ Enable this option if you want to enable the SPI memory extension.
+ This extension is meant to simplify interaction with SPI memories
+ by providing an high-level interface to send memory-like commands.
+
config ALTERA_SPI
bool "Altera SPI driver"
help
access the SPI NOR flash on platforms embedding these Broadcom
SPI cores.
+config BCMSTB_SPI
+ bool "BCMSTB SPI driver"
+ help
+ Enable the Broadcom set-top box SPI driver. This driver can
+ be used to access the SPI flash on platforms embedding this
+ Broadcom SPI core.
+
config CADENCE_QSPI
bool "Cadence QSPI driver"
help
access the SPI NOR flash on platforms embedding this Intel
ICH IP core.
+config MT7621_SPI
+ bool "MediaTek MT7621 SPI driver"
+ depends on ARCH_MT7620
+ help
+ Enable the MT7621 SPI driver. This driver can be used to access
+ the SPI NOR flash on platforms embedding this Ralink / MediaTek
+ SPI core, like MT7621/7628/7688.
+
config MVEBU_A3700_SPI
bool "Marvell Armada 3700 SPI driver"
+ select CLK_ARMADA_3720
help
Enable the Marvell Armada 3700 SPI driver. This driver can be
used to access the SPI NOR flash on platforms embedding this
to access the SPI NOR flash, MMC-over-SPI on platforms based on
Microchip PIC32 family devices.
+config PL022_SPI
+ bool "ARM AMBA PL022 SSP controller driver"
+ depends on ARM
+ help
+ This selects the ARM(R) AMBA(R) PrimeCell PL022 SSP
+ controller. If you have an embedded system with an AMBA(R)
+ bus and a PL022 controller, say Y or M here.
+
config RENESAS_RPC_SPI
bool "Renesas RPC SPI driver"
depends on RCAR_GEN3
used to access the SPI NOR flash chips on platforms embedding
this ST IP core.
+config SUN4I_SPI
+ bool "Allwinner A10 SoCs SPI controller"
+ help
+ SPI driver for Allwinner sun4i, sun5i and sun7i SoCs
+
config TEGRA114_SPI
bool "nVidia Tegra114 SPI driver"
help
Zynq QSPI IP core. This IP is used to connect the flash in
4-bit qspi, 8-bit dual stacked and shared 4-bit dual parallel.
+config ZYNQMP_GQSPI
+ bool "Configure ZynqMP Generic QSPI"
+ depends on ARCH_ZYNQMP
+ help
+ This option is used to enable ZynqMP QSPI controller driver which
+ is used to communicate with qspi flash devices.
+
endif # if DM_SPI
config SOFT_SPI