#define RTC_YR_REG_ADDR 0x6
#define RTC_CTL_REG_ADDR 0x0e
#define RTC_STAT_REG_ADDR 0x0f
+#define RTC_TC_REG_ADDR 0x10
/*
* RTC control register bits
static uchar rtc_read (uchar reg);
static void rtc_write (uchar reg, uchar val);
-static uchar bin2bcd (unsigned int n);
-static unsigned bcd2bin (uchar c);
-
/*
* Get the current time from the RTC
/*
* Set the RTC
*/
-void rtc_set (struct rtc_time *tmp)
+int rtc_set (struct rtc_time *tmp)
{
uchar century;
rtc_write (RTC_HR_REG_ADDR, bin2bcd (tmp->tm_hour));
rtc_write (RTC_MIN_REG_ADDR, bin2bcd (tmp->tm_min));
rtc_write (RTC_SEC_REG_ADDR, bin2bcd (tmp->tm_sec));
+
+ return 0;
}
* SQW/INTB* pin and program it for 32,768 Hz output. Note that
* according to the datasheet, turning on the square wave output
* increases the current drain on the backup battery from about
- * 600 nA to 2uA. Define CFG_RTC_DS1337_NOOSC if you wish to turn
+ * 600 nA to 2uA. Define CONFIG_SYS_RTC_DS1337_NOOSC if you wish to turn
* off the OSC output.
*/
-#ifdef CFG_RTC_DS1337_NOOSC
+#ifdef CONFIG_SYS_RTC_DS1337_NOOSC
#define RTC_DS1337_RESET_VAL \
(RTC_CTL_BIT_INTCN | RTC_CTL_BIT_RS1 | RTC_CTL_BIT_RS2)
#else
void rtc_reset (void)
{
rtc_write (RTC_CTL_REG_ADDR, RTC_DS1337_RESET_VAL);
+#ifdef CONFIG_SYS_DS1339_TCR_VAL
+ rtc_write (RTC_TC_REG_ADDR, CONFIG_SYS_DS1339_TCR_VAL);
+#endif
}
static
uchar rtc_read (uchar reg)
{
- return (i2c_reg_read (CFG_I2C_RTC_ADDR, reg));
+ return (i2c_reg_read (CONFIG_SYS_I2C_RTC_ADDR, reg));
}
static void rtc_write (uchar reg, uchar val)
{
- i2c_reg_write (CFG_I2C_RTC_ADDR, reg, val);
-}
-
-static unsigned bcd2bin (uchar n)
-{
- return ((((n >> 4) & 0x0F) * 10) + (n & 0x0F));
-}
-
-static unsigned char bin2bcd (unsigned int n)
-{
- return (((n / 10) << 4) | (n % 10));
+ i2c_reg_write (CONFIG_SYS_I2C_RTC_ADDR, reg, val);
}
#endif