menuconfig PHYLIB
bool "Ethernet PHY (physical media interface) support"
+ depends on NET
help
Enable Ethernet PHY (physical media interface) support.
if PHYLIB
+config PHY_ADDR_ENABLE
+ bool "Limit phy address"
+ default y if ARCH_SUNXI
+ help
+ Select this if you want to control which phy address is used
+
+if PHY_ADDR_ENABLE
+config PHY_ADDR
+ int "PHY address"
+ default 1 if ARCH_SUNXI
+ default 0
+ help
+ The address of PHY on MII bus. Usually in range of 0 to 31.
+endif
+
+config B53_SWITCH
+ bool "Broadcom BCM53xx (RoboSwitch) Ethernet switch PHY support."
+ help
+ Enable support for Broadcom BCM53xx (RoboSwitch) Ethernet switches.
+ This currently supports BCM53125 and similar models.
+
+if B53_SWITCH
+
+config B53_CPU_PORT
+ int "CPU port"
+ default 8
+
+config B53_PHY_PORTS
+ hex "Bitmask of PHY ports"
+
+endif # B53_SWITCH
+
config MV88E61XX_SWITCH
bool "Marvel MV88E61xx Ethernet switch PHY support."
config PHYLIB_10G
bool "Generic 10G PHY support"
-config PHY_AQUANTIA
+menuconfig PHY_AQUANTIA
bool "Aquantia Ethernet PHYs support"
+ select PHY_GIGE
+ select PHYLIB_10G
+
+config PHY_AQUANTIA_UPLOAD_FW
+ bool "Aquantia firmware loading support"
+ default n
+ depends on PHY_AQUANTIA
+ help
+ Aquantia PHYs use firmware which can be either loaded automatically
+ from storage directly attached to the phy or loaded by the boot loader
+ via MDIO commands. The firmware is loaded from a file, specified by
+ the PHY_AQUANTIA_FW_PART and PHY_AQUANTIA_FW_NAME options.
+
+config PHY_AQUANTIA_FW_PART
+ string "Aquantia firmware partition"
+ depends on PHY_AQUANTIA_UPLOAD_FW
+ help
+ Partition containing the firmware file.
+
+config PHY_AQUANTIA_FW_NAME
+ string "Aquantia firmware filename"
+ depends on PHY_AQUANTIA_UPLOAD_FW
+ help
+ Firmware filename.
config PHY_ATHEROS
bool "Atheros Ethernet PHYs support"
config PHY_REALTEK
bool "Realtek Ethernet PHYs support"
+config RTL8211E_PINE64_GIGABIT_FIX
+ bool "Fix gigabit throughput on some Pine64+ models"
+ depends on PHY_REALTEK
+ help
+ Configure the Realtek RTL8211E found on some Pine64+ models differently to
+ fix throughput on Gigabit links, turning off all internal delays in the
+ process. The settings that this touches are not documented in the CONFREG
+ section of the RTL8211E datasheet, but come from Realtek by way of the
+ Pine64 engineering team.
+
config RTL8211X_PHY_FORCE_MASTER
bool "Ethernet PHY RTL8211x: force 1000BASE-T master mode"
depends on PHY_REALTEK