mmc: tmio: sdhi: Move tap_pos to private data
[oweals/u-boot.git] / drivers / mmc / stm32_sdmmc2.c
index e8292c438d9f712503f79bcc0776cab6ff9aebf1..a36612dd937e72fe3182bff10b6bfb8c0ca189b5 100644 (file)
@@ -56,7 +56,10 @@ struct stm32_sdmmc2_ctx {
 #define SDMMC_IDMABASE0                0x58    /* SDMMC DMA buffer 0 base address */
 
 /* SDMMC_POWER register */
-#define SDMMC_POWER_PWRCTRL            GENMASK(1, 0)
+#define SDMMC_POWER_PWRCTRL_MASK       GENMASK(1, 0)
+#define SDMMC_POWER_PWRCTRL_OFF                0
+#define SDMMC_POWER_PWRCTRL_CYCLE      2
+#define SDMMC_POWER_PWRCTRL_ON         3
 #define SDMMC_POWER_VSWITCH            BIT(2)
 #define SDMMC_POWER_VSWITCHEN          BIT(3)
 #define SDMMC_POWER_DIRPOL             BIT(4)
@@ -440,23 +443,74 @@ retry_cmd:
        return ret;
 }
 
-static void stm32_sdmmc2_pwron(struct stm32_sdmmc2_priv *priv)
+/*
+ * Reset the SDMMC with the RCC.SDMMCxRST register bit.
+ * This will reset the SDMMC to the reset state and the CPSM and DPSM
+ * to the Idle state. SDMMC is disabled, Signals Hiz.
+ */
+static void stm32_sdmmc2_reset(struct stm32_sdmmc2_priv *priv)
 {
        /* Reset */
        reset_assert(&priv->reset_ctl);
        udelay(2);
        reset_deassert(&priv->reset_ctl);
 
-       udelay(1000);
+       /* init the needed SDMMC register after reset */
+       writel(priv->pwr_reg_msk, priv->base + SDMMC_POWER);
+}
+
+/*
+ * Set the SDMMC in power-cycle state.
+ * This will make that the SDMMC_D[7:0],
+ * SDMMC_CMD and SDMMC_CK are driven low, to prevent the card from being
+ * supplied through the signal lines.
+ */
+static void stm32_sdmmc2_pwrcycle(struct stm32_sdmmc2_priv *priv)
+{
+       if ((readl(priv->base + SDMMC_POWER) & SDMMC_POWER_PWRCTRL_MASK) ==
+           SDMMC_POWER_PWRCTRL_CYCLE)
+               return;
 
-       /* Set Power State to ON */
-       writel(SDMMC_POWER_PWRCTRL | priv->pwr_reg_msk, priv->base + SDMMC_POWER);
+       stm32_sdmmc2_reset(priv);
+       writel(SDMMC_POWER_PWRCTRL_CYCLE | priv->pwr_reg_msk,
+              priv->base + SDMMC_POWER);
+}
+
+/*
+ * set the SDMMC state Power-on: the card is clocked
+ * manage the SDMMC state control:
+ * Reset => Power-Cycle => Power-Off => Power
+ *    PWRCTRL=10     PWCTRL=00    PWCTRL=11
+ */
+static void stm32_sdmmc2_pwron(struct stm32_sdmmc2_priv *priv)
+{
+       u32 pwrctrl =
+               readl(priv->base + SDMMC_POWER) &  SDMMC_POWER_PWRCTRL_MASK;
+
+       if (pwrctrl == SDMMC_POWER_PWRCTRL_ON)
+               return;
+
+       /* warning: same PWRCTRL value after reset and for power-off state
+        * it is the reset state here = the only managed by the driver
+        */
+       if (pwrctrl == SDMMC_POWER_PWRCTRL_OFF) {
+               writel(SDMMC_POWER_PWRCTRL_CYCLE | priv->pwr_reg_msk,
+                      priv->base + SDMMC_POWER);
+       }
 
        /*
-        * 1ms: required power up waiting time before starting the
-        * SD initialization sequence
+        * the remaining case is SDMMC_POWER_PWRCTRL_CYCLE
+        * switch to Power-Off state: SDMCC disable, signals drive 1
         */
-       udelay(1000);
+       writel(SDMMC_POWER_PWRCTRL_OFF | priv->pwr_reg_msk,
+              priv->base + SDMMC_POWER);
+
+       /* After the 1ms delay set the SDMMC to power-on */
+       mdelay(1);
+       writel(SDMMC_POWER_PWRCTRL_ON | priv->pwr_reg_msk,
+              priv->base + SDMMC_POWER);
+
+       /* during the first 74 SDMMC_CK cycles the SDMMC is still disabled. */
 }
 
 #define IS_RISING_EDGE(reg) (reg & SDMMC_CLKCR_NEGEDGE ? 0 : 1)
@@ -464,8 +518,6 @@ static int stm32_sdmmc2_set_ios(struct udevice *dev)
 {
        struct mmc *mmc = mmc_get_mmc_dev(dev);
        struct stm32_sdmmc2_priv *priv = dev_get_priv(dev);
-       struct stm32_sdmmc2_plat *plat = dev_get_platdata(dev);
-       struct mmc_config *cfg = &plat->cfg;
        u32 desired = mmc->clock;
        u32 sys_clock = clk_get_rate(&priv->clk);
        u32 clk = 0;
@@ -473,7 +525,9 @@ static int stm32_sdmmc2_set_ios(struct udevice *dev)
        debug("%s: bus_with = %d, clock = %d\n", __func__,
              mmc->bus_width, mmc->clock);
 
-       if ((mmc->bus_width == 1) && (desired == cfg->f_min))
+       if (mmc->clk_disable)
+               stm32_sdmmc2_pwrcycle(priv);
+       else
                stm32_sdmmc2_pwron(priv);
 
        /*
@@ -577,6 +631,8 @@ static int stm32_sdmmc2_probe(struct udevice *dev)
 
        upriv->mmc = &plat->mmc;
 
+       /* SDMMC init */
+       stm32_sdmmc2_reset(priv);
        return 0;
 
 clk_disable: