/*
- * Copyright 2007,2010 Freescale Semiconductor, Inc
+ * Copyright 2007, 2010-2011 Freescale Semiconductor, Inc
* Andy Fleming
*
* Based vaguely on the pxa mmc code:
uint xfertyp = 0;
if (data) {
- xfertyp |= XFERTYP_DPSEL | XFERTYP_DMAEN;
-
+ xfertyp |= XFERTYP_DPSEL;
+#ifndef CONFIG_SYS_FSL_ESDHC_USE_PIO
+ xfertyp |= XFERTYP_DMAEN;
+#endif
if (data->blocks > 1) {
xfertyp |= XFERTYP_MSBSEL;
xfertyp |= XFERTYP_BCEN;
+#ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC111
+ xfertyp |= XFERTYP_AC12EN;
+#endif
}
if (data->flags & MMC_DATA_READ)
return XFERTYP_CMD(cmd->cmdidx) | xfertyp;
}
+#ifdef CONFIG_SYS_FSL_ESDHC_USE_PIO
+/*
+ * PIO Read/Write Mode reduce the performace as DMA is not used in this mode.
+ */
+static void
+esdhc_pio_read_write(struct mmc *mmc, struct mmc_data *data)
+{
+ struct fsl_esdhc *regs = mmc->priv;
+ uint blocks;
+ char *buffer;
+ uint databuf;
+ uint size;
+ uint irqstat;
+ uint timeout;
+
+ if (data->flags & MMC_DATA_READ) {
+ blocks = data->blocks;
+ buffer = data->dest;
+ while (blocks) {
+ timeout = PIO_TIMEOUT;
+ size = data->blocksize;
+ irqstat = esdhc_read32(®s->irqstat);
+ while (!(esdhc_read32(®s->prsstat) & PRSSTAT_BREN)
+ && --timeout);
+ if (timeout <= 0) {
+ printf("\nData Read Failed in PIO Mode.");
+ return;
+ }
+ while (size && (!(irqstat & IRQSTAT_TC))) {
+ udelay(100); /* Wait before last byte transfer complete */
+ irqstat = esdhc_read32(®s->irqstat);
+ databuf = in_le32(®s->datport);
+ *((uint *)buffer) = databuf;
+ buffer += 4;
+ size -= 4;
+ }
+ blocks--;
+ }
+ } else {
+ blocks = data->blocks;
+ buffer = (char *)data->src;
+ while (blocks) {
+ timeout = PIO_TIMEOUT;
+ size = data->blocksize;
+ irqstat = esdhc_read32(®s->irqstat);
+ while (!(esdhc_read32(®s->prsstat) & PRSSTAT_BWEN)
+ && --timeout);
+ if (timeout <= 0) {
+ printf("\nData Write Failed in PIO Mode.");
+ return;
+ }
+ while (size && (!(irqstat & IRQSTAT_TC))) {
+ udelay(100); /* Wait before last byte transfer complete */
+ databuf = *((uint *)buffer);
+ buffer += 4;
+ size -= 4;
+ irqstat = esdhc_read32(®s->irqstat);
+ out_le32(®s->datport, databuf);
+ }
+ blocks--;
+ }
+ }
+}
+#endif
+
static int esdhc_setup_data(struct mmc *mmc, struct mmc_data *data)
{
- uint wml_value;
int timeout;
struct fsl_esdhc_cfg *cfg = (struct fsl_esdhc_cfg *)mmc->priv;
struct fsl_esdhc *regs = (struct fsl_esdhc *)cfg->esdhc_base;
+#ifndef CONFIG_SYS_FSL_ESDHC_USE_PIO
+ uint wml_value;
wml_value = data->blocksize/4;
wml_value << 16);
esdhc_write32(®s->dsaddr, (u32)data->src);
}
+#else /* CONFIG_SYS_FSL_ESDHC_USE_PIO */
+ if (!(data->flags & MMC_DATA_READ)) {
+ if ((esdhc_read32(®s->prsstat) & PRSSTAT_WPSPL) == 0) {
+ printf("\nThe SD card is locked. "
+ "Can not write to a locked card.\n\n");
+ return TIMEOUT;
+ }
+ esdhc_write32(®s->dsaddr, (u32)data->src);
+ } else
+ esdhc_write32(®s->dsaddr, (u32)data->dest);
+#endif /* CONFIG_SYS_FSL_ESDHC_USE_PIO */
esdhc_write32(®s->blkattr, data->blocks << 16 | data->blocksize);
if (timeout < 0)
timeout = 0;
+#ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC_A001
+ if ((timeout == 4) || (timeout == 8) || (timeout == 12))
+ timeout++;
+#endif
+
esdhc_clrsetbits32(®s->sysctl, SYSCTL_TIMEOUT_MASK, timeout << 16);
return 0;
struct fsl_esdhc_cfg *cfg = (struct fsl_esdhc_cfg *)mmc->priv;
volatile struct fsl_esdhc *regs = (struct fsl_esdhc *)cfg->esdhc_base;
+#ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC111
+ if (cmd->cmdidx == MMC_CMD_STOP_TRANSMISSION)
+ return 0;
+#endif
+
esdhc_write32(®s->irqstat, -1);
sync();
/* Wait until all of the blocks are transferred */
if (data) {
+#ifdef CONFIG_SYS_FSL_ESDHC_USE_PIO
+ esdhc_pio_read_write(mmc, data);
+#else
do {
irqstat = esdhc_read32(®s->irqstat);
return TIMEOUT;
} while (!(irqstat & IRQSTAT_TC) &&
(esdhc_read32(®s->prsstat) & PRSSTAT_DLA));
+#endif
}
esdhc_write32(®s->irqstat, -1);
int ret = 0;
u8 card_absent;
- /* Enable cache snooping */
- if (cfg && !cfg->no_snoop)
- esdhc_write32(®s->scr, 0x00000040);
-
/* Reset the entire host controller */
esdhc_write32(®s->sysctl, SYSCTL_RSTA);
while ((esdhc_read32(®s->sysctl) & SYSCTL_RSTA) && --timeout)
udelay(1000);
+ /* Enable cache snooping */
+ if (cfg && !cfg->no_snoop)
+ esdhc_write32(®s->scr, 0x00000040);
+
esdhc_write32(®s->sysctl, SYSCTL_HCKEN | SYSCTL_IPGEN);
/* Set the initial clock speed */
- set_sysctl(mmc, 400000);
+ mmc_set_clock(mmc, 400000);
/* Disable the BRR and BWR bits in IRQSTAT */
esdhc_clrbits32(®s->irqstaten, IRQSTATEN_BRR | IRQSTATEN_BWR);
{
struct fsl_esdhc *regs;
struct mmc *mmc;
- u32 caps;
+ u32 caps, voltage_caps;
if (!cfg)
return -1;
mmc->set_ios = esdhc_set_ios;
mmc->init = esdhc_init;
+ voltage_caps = 0;
caps = regs->hostcapblt;
+#ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC135
+ caps = caps & ~(ESDHC_HOSTCAPBLT_SRS |
+ ESDHC_HOSTCAPBLT_VS18 | ESDHC_HOSTCAPBLT_VS30);
+#endif
if (caps & ESDHC_HOSTCAPBLT_VS18)
- mmc->voltages |= MMC_VDD_165_195;
+ voltage_caps |= MMC_VDD_165_195;
if (caps & ESDHC_HOSTCAPBLT_VS30)
- mmc->voltages |= MMC_VDD_29_30 | MMC_VDD_30_31;
+ voltage_caps |= MMC_VDD_29_30 | MMC_VDD_30_31;
if (caps & ESDHC_HOSTCAPBLT_VS33)
- mmc->voltages |= MMC_VDD_32_33 | MMC_VDD_33_34;
+ voltage_caps |= MMC_VDD_32_33 | MMC_VDD_33_34;
+
+#ifdef CONFIG_SYS_SD_VOLTAGE
+ mmc->voltages = CONFIG_SYS_SD_VOLTAGE;
+#else
+ mmc->voltages = MMC_VDD_32_33 | MMC_VDD_33_34;
+#endif
+ if ((mmc->voltages & voltage_caps) == 0) {
+ printf("voltage not supported by controller\n");
+ return -1;
+ }
mmc->host_caps = MMC_MODE_4BIT | MMC_MODE_8BIT;
mmc->host_caps |= MMC_MODE_HS_52MHz | MMC_MODE_HS;
mmc->f_min = 400000;
- mmc->f_max = MIN(gd->sdhc_clk, 50000000);
+ mmc->f_max = MIN(gd->sdhc_clk, 52000000);
mmc_register(mmc);
void fdt_fixup_esdhc(void *blob, bd_t *bd)
{
const char *compat = "fsl,esdhc";
- const char *status = "okay";
+#ifdef CONFIG_FSL_ESDHC_PIN_MUX
if (!hwconfig("esdhc")) {
- status = "disabled";
- goto out;
+ do_fixup_by_compat(blob, compat, "status", "disabled",
+ 8 + 1, 1);
+ return;
}
+#endif
do_fixup_by_compat_u32(blob, compat, "clock-frequency",
gd->sdhc_clk, 1);
-out:
- do_fixup_by_compat(blob, compat, "status", status,
- strlen(status) + 1, 1);
+
+ do_fixup_by_compat(blob, compat, "status", "okay",
+ 4 + 1, 1);
}
#endif