DECLARE_GLOBAL_DATA_PTR;
+#define SDHCI_IRQ_EN_BITS (IRQSTATEN_CC | IRQSTATEN_TC | \
+ IRQSTATEN_CINT | \
+ IRQSTATEN_CTOE | IRQSTATEN_CCE | IRQSTATEN_CEBE | \
+ IRQSTATEN_CIE | IRQSTATEN_DTOE | IRQSTATEN_DCE | \
+ IRQSTATEN_DEBE | IRQSTATEN_BRR | IRQSTATEN_BWR | \
+ IRQSTATEN_DINT)
+
struct fsl_esdhc {
uint dsaddr; /* SDMA system address register */
uint blkattr; /* Block attributes register */
uint fevt; /* Force event register */
uint admaes; /* ADMA error status register */
uint adsaddr; /* ADMA system address register */
- char reserved2[160]; /* reserved */
+ char reserved2[100]; /* reserved */
+ uint vendorspec; /* Vendor Specific register */
+ char reserved3[56]; /* reserved */
uint hostver; /* Host controller version register */
- char reserved3[4]; /* reserved */
- uint dmaerraddr; /* DMA error address register */
char reserved4[4]; /* reserved */
- uint dmaerrattr; /* DMA error attribute register */
+ uint dmaerraddr; /* DMA error address register */
char reserved5[4]; /* reserved */
+ uint dmaerrattr; /* DMA error attribute register */
+ char reserved6[4]; /* reserved */
uint hostcapblt2; /* Host controller capabilities register 2 */
- char reserved6[8]; /* reserved */
+ char reserved7[8]; /* reserved */
uint tcr; /* Tuning control register */
- char reserved7[28]; /* reserved */
+ char reserved8[28]; /* reserved */
uint sddirctl; /* SD direction control register */
- char reserved8[712]; /* reserved */
+ char reserved9[712]; /* reserved */
uint scr; /* eSDHC control register */
};
else if (cmd->resp_type & MMC_RSP_PRESENT)
xfertyp |= XFERTYP_RSPTYP_48;
-#if defined(CONFIG_MX53) || defined(CONFIG_T4240QDS)
+#if defined(CONFIG_MX53) || defined(CONFIG_PPC_T4240) || defined(CONFIG_LS102XA)
if (cmd->cmdidx == MMC_CMD_STOP_TRANSMISSION)
xfertyp |= XFERTYP_CMDTYP_ABORT;
#endif
int timeout;
struct fsl_esdhc_cfg *cfg = mmc->priv;
struct fsl_esdhc *regs = (struct fsl_esdhc *)cfg->esdhc_base;
-#ifndef CONFIG_SYS_FSL_ESDHC_USE_PIO
+
uint wml_value;
wml_value = data->blocksize/4;
wml_value = WML_RD_WML_MAX_VAL;
esdhc_clrsetbits32(®s->wml, WML_RD_WML_MASK, wml_value);
+#ifndef CONFIG_SYS_FSL_ESDHC_USE_PIO
esdhc_write32(®s->dsaddr, (u32)data->dest);
+#endif
} else {
+#ifndef CONFIG_SYS_FSL_ESDHC_USE_PIO
flush_dcache_range((ulong)data->src,
(ulong)data->src+data->blocks
*data->blocksize);
-
+#endif
if (wml_value > WML_WR_WML_MAX)
wml_value = WML_WR_WML_MAX_VAL;
if ((esdhc_read32(®s->prsstat) & PRSSTAT_WPSPL) == 0) {
esdhc_clrsetbits32(®s->wml, WML_WR_WML_MASK,
wml_value << 16);
+#ifndef CONFIG_SYS_FSL_ESDHC_USE_PIO
esdhc_write32(®s->dsaddr, (u32)data->src);
+#endif
}
-#else /* CONFIG_SYS_FSL_ESDHC_USE_PIO */
- if (!(data->flags & MMC_DATA_READ)) {
- if ((esdhc_read32(®s->prsstat) & PRSSTAT_WPSPL) == 0) {
- printf("\nThe SD card is locked. "
- "Can not write to a locked card.\n\n");
- return TIMEOUT;
- }
- esdhc_write32(®s->dsaddr, (u32)data->src);
- } else
- esdhc_write32(®s->dsaddr, (u32)data->dest);
-#endif /* CONFIG_SYS_FSL_ESDHC_USE_PIO */
esdhc_write32(®s->blkattr, data->blocks << 16 | data->blocksize);
timeout++;
#endif
+#ifdef ESDHCI_QUIRK_BROKEN_TIMEOUT_VALUE
+ timeout = 0xE;
+#endif
esdhc_clrsetbits32(®s->sysctl, SYSCTL_TIMEOUT_MASK, timeout << 16);
return 0;
}
+#ifndef CONFIG_SYS_FSL_ESDHC_USE_PIO
static void check_and_invalidate_dcache_range
(struct mmc_cmd *cmd,
struct mmc_data *data) {
unsigned end = start+size ;
invalidate_dcache_range(start, end);
}
+#endif
+
/*
* Sends a command out on the bus. Takes the mmc pointer,
* a command pointer, and an optional data pointer.
static int
esdhc_send_cmd(struct mmc *mmc, struct mmc_cmd *cmd, struct mmc_data *data)
{
+ int err = 0;
uint xfertyp;
uint irqstat;
struct fsl_esdhc_cfg *cfg = mmc->priv;
/* Set up for a data transfer if we have one */
if (data) {
- int err;
-
err = esdhc_setup_data(mmc, data);
if(err)
return err;
esdhc_write32(®s->cmdarg, cmd->cmdarg);
#if defined(CONFIG_FSL_USDHC)
esdhc_write32(®s->mixctrl,
- (esdhc_read32(®s->mixctrl) & 0xFFFFFF80) | (xfertyp & 0x7F));
+ (esdhc_read32(®s->mixctrl) & 0xFFFFFF80) | (xfertyp & 0x7F)
+ | (mmc->ddr_mode ? XFERTYP_DDREN : 0));
esdhc_write32(®s->xfertyp, xfertyp & 0xFFFF0000);
#else
esdhc_write32(®s->xfertyp, xfertyp);
irqstat = esdhc_read32(®s->irqstat);
- /* Reset CMD and DATA portions on error */
- if (irqstat & (CMD_ERR | IRQSTAT_CTOE)) {
- esdhc_write32(®s->sysctl, esdhc_read32(®s->sysctl) |
- SYSCTL_RSTC);
- while (esdhc_read32(®s->sysctl) & SYSCTL_RSTC)
- ;
+ if (irqstat & CMD_ERR) {
+ err = COMM_ERR;
+ goto out;
+ }
- if (data) {
- esdhc_write32(®s->sysctl,
- esdhc_read32(®s->sysctl) |
- SYSCTL_RSTD);
- while ((esdhc_read32(®s->sysctl) & SYSCTL_RSTD))
- ;
- }
+ if (irqstat & IRQSTAT_CTOE) {
+ err = TIMEOUT;
+ goto out;
}
- if (irqstat & CMD_ERR)
- return COMM_ERR;
+ /* Switch voltage to 1.8V if CMD11 succeeded */
+ if (cmd->cmdidx == SD_CMD_SWITCH_UHS18V) {
+ esdhc_setbits32(®s->vendorspec, ESDHC_VENDORSPEC_VSELECT);
- if (irqstat & IRQSTAT_CTOE)
- return TIMEOUT;
+ printf("Run CMD11 1.8V switch\n");
+ /* Sleep for 5 ms - max time for card to switch to 1.8V */
+ udelay(5000);
+ }
/* Workaround for ESDHC errata ENGcm03648 */
if (!data && (cmd->resp_type & MMC_RSP_BUSY)) {
if (timeout <= 0) {
printf("Timeout waiting for DAT0 to go high!\n");
- return TIMEOUT;
+ err = TIMEOUT;
+ goto out;
}
}
do {
irqstat = esdhc_read32(®s->irqstat);
- if (irqstat & IRQSTAT_DTOE)
- return TIMEOUT;
+ if (irqstat & IRQSTAT_DTOE) {
+ err = TIMEOUT;
+ goto out;
+ }
- if (irqstat & DATA_ERR)
- return COMM_ERR;
+ if (irqstat & DATA_ERR) {
+ err = COMM_ERR;
+ goto out;
+ }
} while ((irqstat & DATA_COMPLETE) != DATA_COMPLETE);
-#endif
+
if (data->flags & MMC_DATA_READ)
check_and_invalidate_dcache_range(cmd, data);
+#endif
+ }
+
+out:
+ /* Reset CMD and DATA portions on error */
+ if (err) {
+ esdhc_write32(®s->sysctl, esdhc_read32(®s->sysctl) |
+ SYSCTL_RSTC);
+ while (esdhc_read32(®s->sysctl) & SYSCTL_RSTC)
+ ;
+
+ if (data) {
+ esdhc_write32(®s->sysctl,
+ esdhc_read32(®s->sysctl) |
+ SYSCTL_RSTD);
+ while ((esdhc_read32(®s->sysctl) & SYSCTL_RSTD))
+ ;
+ }
+
+ /* If this was CMD11, then notify that power cycle is needed */
+ if (cmd->cmdidx == SD_CMD_SWITCH_UHS18V)
+ printf("CMD11 to switch to 1.8V mode failed, card requires power cycle.\n");
}
esdhc_write32(®s->irqstat, -1);
- return 0;
+ return err;
}
static void set_sysctl(struct mmc *mmc, uint clock)
if ((sdhc_clk / (div * pre_div)) <= clock)
break;
- pre_div >>= 1;
+ pre_div >>= mmc->ddr_mode ? 2 : 1;
div -= 1;
clk = (pre_div << 8) | (div << 4);
/* Set timout to the maximum value */
esdhc_clrsetbits32(®s->sysctl, SYSCTL_TIMEOUT_MASK, 14 << 16);
+#ifdef CONFIG_SYS_FSL_ESDHC_FORCE_VSELECT
+ esdhc_setbits32(®s->vendorspec, ESDHC_VENDORSPEC_VSELECT);
+#endif
+
return 0;
}
esdhc_setbits32(®s->sysctl, SYSCTL_PEREN | SYSCTL_HCKEN
| SYSCTL_IPGEN | SYSCTL_CKEN);
+ writel(SDHCI_IRQ_EN_BITS, ®s->irqstaten);
memset(&cfg->cfg, 0, sizeof(cfg->cfg));
voltage_caps = 0;
- caps = regs->hostcapblt;
+ caps = esdhc_read32(®s->hostcapblt);
#ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC135
caps = caps & ~(ESDHC_HOSTCAPBLT_SRS |
}
cfg->cfg.host_caps = MMC_MODE_4BIT | MMC_MODE_8BIT | MMC_MODE_HC;
+#ifdef CONFIG_SYS_FSL_ESDHC_HAS_DDR_MODE
+ cfg->cfg.host_caps |= MMC_MODE_DDR_52MHz;
+#endif
if (cfg->max_bus_width > 0) {
if (cfg->max_bus_width < 8)
#endif
cfg->cfg.f_min = 400000;
- cfg->cfg.f_max = MIN(gd->arch.sdhc_clk, 52000000);
+ cfg->cfg.f_max = min(cfg->sdhc_clk, (u32)52000000);
cfg->cfg.b_max = CONFIG_SYS_MMC_MAX_BLK_COUNT;