Add SSL_CONF command to set DH Parameters.

[oweals/openssl.git] / doc / ssl / SSL_connect.pod

diff --git a/doc/ssl/SSL_connect.pod b/doc/ssl/SSL_connect.pod
index 8426310c0d268e975700cc75aab77140613c00b3..946ca89d7b7d7e604fd7253bbb7f71a2976706a0 100644 (file)
--- a/doc/ssl/SSL_connect.pod
+++ b/doc/ssl/SSL_connect.pod
@@ -25,7 +25,8 @@ handshake has been finished or an error occurred.
 
 If the underlying BIO is B<non-blocking>, SSL_connect() will also return
 when the underlying BIO could not satisfy the needs of SSL_connect()
-to continue the handshake. In this case a call to SSL_get_error() with the
+to continue the handshake, indicating the problem by the return value -1.
+In this case a call to SSL_get_error() with the
 return value of SSL_connect() will yield B<SSL_ERROR_WANT_READ> or
 B<SSL_ERROR_WANT_WRITE>. The calling process then must repeat the call after
 taking appropriate action to satisfy the needs of SSL_connect().
@@ -40,17 +41,17 @@ The following return values can occur:
 
 =over 4
 
-=item 1
-
-The TLS/SSL handshake was successfully completed, a TLS/SSL connection has been
-established.
-
 =item 0
 
 The TLS/SSL handshake was not successful but was shut down controlled and
 by the specifications of the TLS/SSL protocol. Call SSL_get_error() with the
 return value B<ret> to find out the reason.
 
+=item 1
+
+The TLS/SSL handshake was successfully completed, a TLS/SSL connection has been
+established.
+
 =item E<lt>0
 
 The TLS/SSL handshake was not successful, because a fatal error occurred either