#include <asm/io.h>
#include <asm/processor.h>
#include <asm/mmu.h>
+#include <asm/cache.h>
#if defined(CONFIG_SPD_EEPROM) && \
(defined(CONFIG_440EPX) || defined(CONFIG_440GRX))
"\n", dimm_num, ranks_on_dimm);
if (ranks_on_dimm > max_ranks_per_dimm) {
printf("WARNING: DRAM DIMM in slot %lu has %lu "
- "ranks.\n");
+ "ranks.\n", dimm_num, ranks_on_dimm);
if (1 == max_ranks_per_dimm) {
printf("Only one rank will be used.\n");
} else {
"and 5.0 are supported.\n");
printf("Make sure the PLB speed is within the supported range "
"of the DIMMs.\n");
- printf("sdram_freq=%d cycle2=%d cycle3=%d cycle4=%d "
- "cycle5=%d\n\n", sdram_freq, cycle_2_0_clk,
+ printf("sdram_freq=%ld cycle2=%ld cycle3=%ld cycle4=%ld "
+ "cycle5=%ld\n\n", sdram_freq, cycle_2_0_clk,
cycle_3_0_clk, cycle_4_0_clk, cycle_5_0_clk);
spd_ddr_init_hang();
}
* banks appropriately. If Auto Memory Configuration is
* not used, it is assumed that no DIMM is plugged
*-----------------------------------------------------------------------------*/
-long int initdram(int board_type)
+phys_size_t initdram(int board_type)
{
unsigned char const iic0_dimm_addr[] = SPD_EEPROM_ADDRESS;
unsigned long dimm_ranks[MAXDIMMS];
if (!is_ecc_enabled()) {
printf(" not");
}
- printf(" enabled, %d MHz", (2 * get_bus_freq(0)) / 1000000);
+ printf(" enabled, %ld MHz", (2 * get_bus_freq(0)) / 1000000);
mfsdram(DDR0_03, val);
printf(", CL%d)", DDR0_03_CASLAT_LIN_DECODE(val) >> 1);