configs: ti: Use addr_fit for run_fit environment variable

[oweals/u-boot.git] / configs / ls1028ardb_tfa_SECURE_BOOT_defconfig

diff --git a/configs/ls1028ardb_tfa_SECURE_BOOT_defconfig b/configs/ls1028ardb_tfa_SECURE_BOOT_defconfig
index e59ab580d5dcf39d5e97a465687edc2d48b8af44..c1e88b546515291b50c761f668a65bfdb5151182 100644 (file)
--- a/configs/ls1028ardb_tfa_SECURE_BOOT_defconfig
+++ b/configs/ls1028ardb_tfa_SECURE_BOOT_defconfig
@@ -1,6 +1,7 @@
 CONFIG_ARM=y
 CONFIG_TARGET_LS1028ARDB=y
 CONFIG_TFABOOT=y
+CONFIG_SYS_MALLOC_F_LEN=0x6000
 CONFIG_SECURE_BOOT=y
 CONFIG_SYS_FSL_SDHC_CLK_DIV=1
 CONFIG_NR_DRAM_BANKS=2
@@ -8,7 +9,6 @@ CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
 CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y
 CONFIG_AHCI=y
 CONFIG_DISTRO_DEFAULTS=y
-# CONFIG_SYS_MALLOC_F is not set
 CONFIG_FIT_VERBOSE=y
 CONFIG_OF_BOARD_SETUP=y
 CONFIG_OF_STDOUT_VIA_ALIAS=y
@@ -31,6 +31,12 @@ CONFIG_NETCONSOLE=y
 CONFIG_DM=y
 CONFIG_SCSI_AHCI=y
 CONFIG_SATA_CEVA=y
+CONFIG_DM_GPIO=y
+CONFIG_DM_I2C=y
+CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
+CONFIG_I2C_DEFAULT_BUS_NUMBER=0
+CONFIG_I2C_MUX=y
+CONFIG_I2C_MUX_PCA954x=y
 CONFIG_DM_MMC=y
 CONFIG_FSL_ESDHC=y
 CONFIG_DM_SPI_FLASH=y
@@ -51,6 +57,8 @@ CONFIG_DM_PCI=y
 CONFIG_DM_PCI_COMPAT=y
 CONFIG_PCIE_ECAM_GENERIC=y
 CONFIG_PCIE_LAYERSCAPE=y
+CONFIG_DM_RTC=y
+CONFIG_RTC_PCF2127=y
 CONFIG_SCSI=y
 CONFIG_DM_SCSI=y
 CONFIG_SYS_NS16550=y