configs: ti: Use addr_fit for run_fit environment variable

[oweals/u-boot.git] / configs / ls1028ardb_tfa_SECURE_BOOT_defconfig

diff --git a/configs/ls1028ardb_tfa_SECURE_BOOT_defconfig b/configs/ls1028ardb_tfa_SECURE_BOOT_defconfig
index a2a218112a38cb984ac422516e9ed4de7ddd4e73..c1e88b546515291b50c761f668a65bfdb5151182 100644 (file)
--- a/configs/ls1028ardb_tfa_SECURE_BOOT_defconfig
+++ b/configs/ls1028ardb_tfa_SECURE_BOOT_defconfig
@@ -1,14 +1,14 @@
 CONFIG_ARM=y
 CONFIG_TARGET_LS1028ARDB=y
+CONFIG_TFABOOT=y
+CONFIG_SYS_MALLOC_F_LEN=0x6000
 CONFIG_SECURE_BOOT=y
 CONFIG_SYS_FSL_SDHC_CLK_DIV=1
-CONFIG_TFABOOT=y
 CONFIG_NR_DRAM_BANKS=2
 CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
 CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y
 CONFIG_AHCI=y
 CONFIG_DISTRO_DEFAULTS=y
-# CONFIG_SYS_MALLOC_F is not set
 CONFIG_FIT_VERBOSE=y
 CONFIG_OF_BOARD_SETUP=y
 CONFIG_OF_STDOUT_VIA_ALIAS=y
@@ -31,6 +31,12 @@ CONFIG_NETCONSOLE=y
 CONFIG_DM=y
 CONFIG_SCSI_AHCI=y
 CONFIG_SATA_CEVA=y
+CONFIG_DM_GPIO=y
+CONFIG_DM_I2C=y
+CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
+CONFIG_I2C_DEFAULT_BUS_NUMBER=0
+CONFIG_I2C_MUX=y
+CONFIG_I2C_MUX_PCA954x=y
 CONFIG_DM_MMC=y
 CONFIG_FSL_ESDHC=y
 CONFIG_DM_SPI_FLASH=y
@@ -40,13 +46,19 @@ CONFIG_SPI_FLASH_STMICRO=y
 # CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
 CONFIG_PHYLIB=y
 CONFIG_PHY_ATHEROS=y
+CONFIG_PHY_VITESSE=y
 CONFIG_DM_ETH=y
+CONFIG_DM_MDIO=y
 CONFIG_PHY_GIGE=y
 CONFIG_E1000=y
+CONFIG_FSL_ENETC=y
 CONFIG_PCI=y
 CONFIG_DM_PCI=y
 CONFIG_DM_PCI_COMPAT=y
+CONFIG_PCIE_ECAM_GENERIC=y
 CONFIG_PCIE_LAYERSCAPE=y
+CONFIG_DM_RTC=y
+CONFIG_RTC_PCF2127=y
 CONFIG_SCSI=y
 CONFIG_DM_SCSI=y
 CONFIG_SYS_NS16550=y