spl: Allow tiny printf() to be controlled in SPL and TPL

[oweals/u-boot.git] / common / spl / Kconfig

diff --git a/common/spl/Kconfig b/common/spl/Kconfig
index 94dcdff806e468f200fcdf6df5d1694f6867fa3e..048b85ba7a2d8446cab3dc6289355a048e83f3d6 100644 (file)
--- a/common/spl/Kconfig
+++ b/common/spl/Kconfig
@@ -115,7 +115,7 @@ if SPL
 
 config SPL_HANDOFF
        bool "Pass hand-off information from SPL to U-Boot proper"
-       depends on HANDOFF
+       depends on HANDOFF && SPL_BLOBLIST
        default y
        help
          This option enables SPL to write handoff information. This can be
@@ -435,6 +435,7 @@ config SPL_HASH_SUPPORT
 
 config TPL_HASH_SUPPORT
        bool "Support hashing drivers in TPL"
+       depends on TPL
        select SHA1
        select SHA256
        help
@@ -962,7 +963,7 @@ config SPL_SERIAL_SUPPORT
          for displaying messages while SPL is running. It also brings in
          printf() and panic() functions. This should normally be enabled
          unless there are space reasons not to. Even then, consider
-         enabling USE_TINY_PRINTF which is a small printf() version.
+         enabling SPL_USE_TINY_PRINTF which is a small printf() version.
 
 config SPL_SPI_FLASH_SUPPORT
        bool "Support SPI flash drivers"
@@ -1156,6 +1157,23 @@ config SPL_OPTEE
          OP-TEE is an open source Trusted OS  which is loaded by SPL.
          More detail at: https://github.com/OP-TEE/optee_os
 
+config SPL_OPENSBI
+       bool "Support RISC-V OpenSBI"
+       depends on RISCV && SPL_RISCV_MMODE && RISCV_SMODE
+       help
+         OpenSBI is an open-source implementation of the RISC-V Supervisor Binary
+         Interface (SBI) specification. U-Boot supports the OpenSBI FW_DYNAMIC
+         firmware. It is loaded and started by U-Boot SPL.
+
+         More details are available at https://github.com/riscv/opensbi and
+         https://github.com/riscv/riscv-sbi-doc
+
+config SPL_OPENSBI_LOAD_ADDR
+       hex "OpenSBI load address"
+       depends on SPL_OPENSBI
+       help
+         Load address of the OpenSBI binary.
+
 config TPL
        bool
        depends on SUPPORT_TPL
@@ -1167,7 +1185,7 @@ if TPL
 
 config TPL_HANDOFF
        bool "Pass hand-off information from TPL to SPL and U-Boot proper"
-       depends on HANDOFF
+       depends on HANDOFF && TPL_BLOBLIST
        default y
        help
          This option enables TPL to write handoff information. This can be