29,916,167 26,005,792 bootm_start
30,361,327 445,160 start_kernel
-config BOOTSTAGE_USER_COUNT
- int "Number of boot ID numbers available for user use"
- default 20
- help
- This is the number of available user bootstage records.
- Each time you call bootstage_mark(BOOTSTAGE_ID_ALLOC, ...)
- a new ID will be allocated from this stash. If you exceed
- the limit, recording will stop.
-
config BOOTSTAGE_RECORD_COUNT
int "Number of boot stage records to store"
default 30
This is the size of the bootstage record list and is the maximum
number of bootstage records that can be recorded.
+config SPL_BOOTSTAGE_RECORD_COUNT
+ int "Number of boot stage records to store for SPL"
+ default 5
+ help
+ This is the size of the bootstage record list and is the maximum
+ number of bootstage records that can be recorded.
+
config BOOTSTAGE_FDT
bool "Store boot timing information in the OS device tree"
depends on BOOTSTAGE
help
This options adds the board specific name to u-boot version.
+config LOGLEVEL
+ int "loglevel"
+ default 4
+ range 0 8
+ help
+ All Messages with a loglevel smaller than the console loglevel will
+ be compiled in. The loglevels are defined as follows:
+
+ 0 (KERN_EMERG) system is unusable
+ 1 (KERN_ALERT) action must be taken immediately
+ 2 (KERN_CRIT) critical conditions
+ 3 (KERN_ERR) error conditions
+ 4 (KERN_WARNING) warning conditions
+ 5 (KERN_NOTICE) normal but significant condition
+ 6 (KERN_INFO) informational
+ 7 (KERN_DEBUG) debug-level messages
+
+config SPL_LOGLEVEL
+ int
+ default LOGLEVEL
+
config SILENT_CONSOLE
bool "Support a silent console"
help
endmenu
-config DTB_RESELECT
- bool "Support swapping dtbs at a later point in boot"
- depends on FIT_EMBED
- help
- It is possible during initial boot you may need to use a generic
- dtb until you can fully determine the board your running on. This
- config allows boards to implement a function at a later point
- during boot to switch to the "correct" dtb.
-
-config FIT_EMBED
- bool "Support a FIT image embedded in the U-boot image"
- help
- This option provides hooks to allow U-boot to parse an
- appended FIT image and enable board specific code to then select
- the correct DTB to be used.
-
config DEFAULT_FDT_FILE
string "Default fdt file"
help