patman: Format checkpatch messages for IDE throwback

[oweals/u-boot.git] / common / Kconfig

diff --git a/common/Kconfig b/common/Kconfig
index a04ee1084fed77200f69dfc12a504979a1ffe3f8..9067d1e277b9438ecb23563165de681377759490 100644 (file)
--- a/common/Kconfig
+++ b/common/Kconfig
@@ -373,9 +373,19 @@ config VERSION_VARIABLE
          Any change to this variable will be reverted at the
          next reset.
 
+config BOARD_LATE_INIT
+       bool
+       help
+         Sometimes board require some initialization code that might
+         require once the actual init done, example saving board specific env,
+         boot-modes etc. which eventually done at late.
+
+         So this config enable the late init code with the help of board_late_init
+         function which should defined on respective boards.
+
 config DISPLAY_CPUINFO
        bool "Display information about the CPU during start up"
-       default y if ARM || BLACKFIN || NIOS2 || X86 || XTENSA
+       default y if ARM || BLACKFIN || NIOS2 || X86 || XTENSA || MPC5xxx
        help
          Display information about the CPU that U-Boot is running on
          when U-Boot starts up. The function print_cpuinfo() is called
@@ -389,4 +399,35 @@ config DISPLAY_BOARDINFO
          when U-Boot starts up. The board function checkboard() is called
          to do this.
 
+menu "Start-up hooks"
+
+config ARCH_EARLY_INIT_R
+       bool "Call arch-specific init soon after relocation"
+       default y if X86
+       help
+         With this option U-Boot will call arch_early_init_r() soon after
+         relocation. Driver model is running by this point, and the cache
+         is on. Note that board_early_init_r() is called first, if
+         enabled. This can be used to set up architecture-specific devices.
+
+config ARCH_MISC_INIT
+       bool "Call arch-specific init after relocation, when console is ready"
+       help
+         With this option U-Boot will call arch_misc_init() after
+         relocation to allow miscellaneous arch-dependent initialisation
+         to be performed. This function should be defined by the board
+         and will be called after the console is set up, after relocaiton.
+
+config BOARD_EARLY_INIT_F
+       bool "Call board-specific init before relocation"
+       default y if X86
+       help
+         Some boards need to perform initialisation as soon as possible
+         after boot. With this option, U-Boot calls board_early_init_f()
+         after driver model is ready in the pre-relocation init sequence.
+         Note that the normal serial console is not yet set up, but the
+         debug UART will be available if enabled.
+
+endmenu
+
 source "common/spl/Kconfig"