x86: qemu: Report high memory in the E820 table

[oweals/u-boot.git] / cmd / Kconfig

diff --git a/cmd/Kconfig b/cmd/Kconfig
index 22a3737b4eb7e1cef740d710fc7b2ee9f9e6c008..98647f58b7acaf8fa3c5b7a31010f260b93d481a 100644 (file)
--- a/cmd/Kconfig
+++ b/cmd/Kconfig
@@ -611,6 +611,20 @@ config CMD_MEMORY
            base - print or set address offset
            loop - initialize loop on address range
 
+config MX_CYCLIC
+       bool "Enable cyclic md/mw commands"
+       depends on CMD_MEMORY
+       help
+          Add the "mdc" and "mwc" memory commands. These are cyclic
+          "md/mw" commands.
+          Examples:
+
+         => mdc.b 10 4 500
+         This command will print 4 bytes (10,11,12,13) each 500 ms.
+
+         => mwc.l 100 12345678 10
+         This command will write 12345678 to address 100 all 10 ms.
+
 config CMD_RANDOM
        bool "random"
        default y
@@ -1042,14 +1056,6 @@ config CMD_PCI
          peripherals. Sub-commands allow bus enumeration, displaying and
          changing configuration space and a few other features.
 
-config CMD_PCMCIA
-       bool "pinit - Set up PCMCIA device"
-       help
-         Provides a means to initialise a PCMCIA (Personal Computer Memory
-         Card International Association) device. This is an old standard from
-         about 1990. These devices are typically removable memory or network
-         cards using a standard 68-pin connector.
-
 config CMD_PINMUX
        bool "pinmux - show pins muxing"
        default y if PINCTRL
@@ -1333,6 +1339,13 @@ config BOOTP_NTPSERVER
        bool "Request & store 'ntpserverip' from BOOTP/DHCP server"
        depends on CMD_BOOTP
 
+config CMD_PCAP
+       bool "pcap capture"
+       help
+         Selecting this will allow capturing all Ethernet packets and store
+         them in physical memory in a PCAP formated file,
+         later to be analyzed by PCAP reader application (IE. WireShark).
+
 config BOOTP_PXE
        bool "Send PXE client arch to BOOTP/DHCP server"
        default y