"\n"
" - start burn-in test application\n"
" The burn-in test could took a while to finish!\n"
- " The content of the onboard EEPROM is modified!\n"
+ " The content of the onboard EEPROM is modified!"
);
"read dip switch on TRAB",
"\n"
" - read state of dip switch (S1) on TRAB board\n"
- " read sequence: 1-2-3-4; ON=1; OFF=0; e.g.: \"0100\"\n"
+ " read sequence: 1-2-3-4; ON=1; OFF=0; e.g.: \"0100\""
);
vcc5v, 1, 1, do_vcc5v,
"read VCC5V on TRAB",
"\n"
- " - read actual value of voltage VCC5V\n"
+ " - read actual value of voltage VCC5V"
);
U_BOOT_CMD(
c_temp, 1, 1, do_contact_temp,
"read contact temperature on TRAB",
- "\n"
+ ""
" - reads the onboard temperature (=contact temperature)\n"
);
"print burn in status on TRAB",
"\n"
" - prints the status variables of the last burn in test\n"
- " stored in the onboard EEPROM on TRAB board\n"
+ " stored in the onboard EEPROM on TRAB board"
);
static int read_dip (void)
"delay\n"
" - contact temperature [1/100 C] is printed endlessly to console\n"
" <delay> specifies the seconds to wait between two measurements\n"
- " For each measurment a timestamp is printeted\n"
+ " For each measurment a timestamp is printeted"
);
#endif