void do_board_detect(void)
{
enable_i2c0_pin_mux();
+#ifndef CONFIG_DM_I2C
i2c_init(CONFIG_SYS_OMAP24_I2C_SPEED, CONFIG_SYS_OMAP24_I2C_SLAVE);
-
+#endif
if (ti_i2c_eeprom_am_get(CONFIG_EEPROM_BUS_ADDRESS,
CONFIG_EEPROM_CHIP_ADDRESS))
printf("ti_i2c_eeprom_init failed\n");
if (board_is_bone() && !strncmp(board_ti_get_rev(), "00A1", 4))
return;
+#ifndef CONFIG_DM_I2C
if (i2c_probe(TPS65217_CHIP_PM))
return;
+#else
+ if (power_tps65217_init(0))
+ return;
+#endif
+
/*
* On Beaglebone White we need to ensure we have AC power
* 1.10V. For MPU voltage we need to switch based on
* the frequency we are running at.
*/
+#ifndef CONFIG_DM_I2C
if (i2c_probe(TPS65910_CTRL_I2C_ADDR))
return;
-
+#else
+ if (power_tps65910_init(0))
+ return;
+#endif
/*
* Depending on MPU clock and PG we will need a different
* VDD to drive at that speed.
if (first_time) {
enable_i2c0_pin_mux();
+#ifndef CONFIG_DM_I2C
i2c_init(CONFIG_SYS_OMAP24_I2C_SPEED,
CONFIG_SYS_OMAP24_I2C_SLAVE);
+#endif
first_time = false;
}
}