- Fix RTS/CTS problem (HW?)
CONFIG_SERIAL_MULTI/CONFIG_SERIAL_SOFTWARE_FIFO hangs after
Switching to interrupt driven serial input mode
-- Make vxWorks start from u-boot. Possible reasons
- - Does vxWorks need an entry for the Machine Check interrupt like this
- tlbentry( 0x40000000, SZ_256M, 0, 1, AC_R|AC_W|AC_X|SA_G|SA_I ) ?
Caveats:
--------
On-Chip Memory
--------------
-0xe0010000- 0xe0013fff CFG_OCM_BASE
+0xe0010000- 0xe0013fff CONFIG_SYS_OCM_BASE
The 440EPx includes a 16K on-chip memory that can be placed however
software chooses.
setup bd flash info
cpu_init_r: (cpu/ppc4xx/cpu_init.c)
peripheral chip select in using defines like
- CFG_EBC_PB0A, CFG_EBC_PB0C from hcu5.h
+ CONFIG_SYS_EBC_PB0A, CONFIG_SYS_EBC_PB0C from hcu5.h
mem_malloc_init
malloc_bin_reloc
- spi_init (r or f)??? (CFG_ENV_IS_IN_EEPROM)
+ spi_init (r or f)??? (CONFIG_ENV_IS_IN_EEPROM)
env_relocated
misc_init_r(bd): (board/netstal/hcu5.c)
ethaddr mit serial number ergänzen
Drivers for serial etc are found under drivers/
Don't ask question if you did not look at the README !!
-Most CFG_* and CONFIG_* switches are mentioned/explained there.
+Most CONFIG_SYS_* and CONFIG_* switches are mentioned/explained there.