Merge branch 'master' of git://git.denx.de/u-boot-nds32
[oweals/u-boot.git] / board / bf518f-ezbrd / bf518f-ezbrd.c
index 2c7961ab7c290e11392649d21ca405485d34e218..09a2353e7d93f26f730e5691507941ca62c22f93 100644 (file)
@@ -14,7 +14,9 @@
 #include <spi.h>
 #include <asm/blackfin.h>
 #include <asm/net.h>
+#include <asm/portmux.h>
 #include <asm/mach-common/bits/otp.h>
+#include <asm/sdh.h>
 
 DECLARE_GLOBAL_DATA_PTR;
 
@@ -25,34 +27,24 @@ int checkboard(void)
        return 0;
 }
 
-phys_size_t initdram(int board_type)
-{
-       gd->bd->bi_memstart = CONFIG_SYS_SDRAM_BASE;
-       gd->bd->bi_memsize = CONFIG_SYS_MAX_RAM_SIZE;
-       return gd->bd->bi_memsize;
-}
-
 #if defined(CONFIG_BFIN_MAC)
 static void board_init_enetaddr(uchar *mac_addr)
 {
+#ifdef CONFIG_SYS_NO_FLASH
+# define USE_MAC_IN_FLASH 0
+#else
+# define USE_MAC_IN_FLASH 1
+#endif
        bool valid_mac = false;
 
-#if 0
-       /* the MAC is stored in OTP memory page 0xDF */
-       uint32_t ret;
-       uint64_t otp_mac;
-
-       ret = bfrom_OtpRead(0xDF, OTP_LOWER_HALF, &otp_mac);
-       if (!(ret & OTP_MASTER_ERROR)) {
-               uchar *otp_mac_p = (uchar *)&otp_mac;
-
-               for (ret = 0; ret < 6; ++ret)
-                       mac_addr[ret] = otp_mac_p[5 - ret];
-
-               if (is_valid_ether_addr(mac_addr))
+       if (USE_MAC_IN_FLASH) {
+               /* we cram the MAC in the last flash sector */
+               uchar *board_mac_addr = (uchar *)0x203F0096;
+               if (is_valid_ether_addr(board_mac_addr)) {
+                       memcpy(mac_addr, board_mac_addr, 6);
                        valid_mac = true;
+               }
        }
-#endif
 
        if (!valid_mac) {
                puts("Warning: Generating 'random' MAC address\n");
@@ -62,30 +54,92 @@ static void board_init_enetaddr(uchar *mac_addr)
        eth_setenv_enetaddr("ethaddr", mac_addr);
 }
 
-int board_eth_init(bd_t *bis)
+/* Only the first run of boards had a KSZ switch */
+#if defined(CONFIG_BFIN_SPI) && __SILICON_REVISION__ == 0
+# define KSZ_POSSIBLE 1
+#else
+# define KSZ_POSSIBLE 0
+#endif
+
+#define KSZ_MAX_HZ    5000000
+
+#define KSZ_WRITE     0x02
+#define KSZ_READ      0x03
+
+#define KSZ_REG_CHID  0x00     /* Register 0: Chip ID0 */
+#define KSZ_REG_STPID 0x01     /* Register 1: Chip ID1 / Start Switch */
+#define KSZ_REG_GC9   0x0b     /* Register 11: Global Control 9 */
+#define KSZ_REG_P3C0  0x30     /* Register 48: Port 3 Control 0 */
+
+static int ksz8893m_transfer(struct spi_slave *slave, uchar dir, uchar reg,
+                            uchar data, uchar result[3])
+{
+       unsigned char dout[3] = { dir, reg, data, };
+       return spi_xfer(slave, sizeof(dout) * 8, dout, result, SPI_XFER_BEGIN | SPI_XFER_END);
+}
+
+static int ksz8893m_reg_set(struct spi_slave *slave, uchar reg, uchar data)
+{
+       unsigned char din[3];
+       return ksz8893m_transfer(slave, KSZ_WRITE, reg, data, din);
+}
+
+static int ksz8893m_reg_read(struct spi_slave *slave, uchar reg)
 {
-       static bool switch_is_alive = false;
        int ret;
+       unsigned char din[3];
+       ret = ksz8893m_transfer(slave, KSZ_READ, reg, 0, din);
+       return ret ? ret : din[2];
+}
+
+static int ksz8893m_reg_clear(struct spi_slave *slave, uchar reg, uchar mask)
+{
+       return ksz8893m_reg_set(slave, reg, ksz8893m_reg_read(slave, reg) & mask);
+}
+
+static int ksz8893m_reset(struct spi_slave *slave)
+{
+       int ret = 0;
+
+       /* Disable STPID mode */
+       ret |= ksz8893m_reg_clear(slave, KSZ_REG_GC9, 0x01);
+
+       /* Disable VLAN tag insert on Port3 */
+       ret |= ksz8893m_reg_clear(slave, KSZ_REG_P3C0, 0x04);
+
+       /* Start switch */
+       ret |= ksz8893m_reg_set(slave, KSZ_REG_STPID, 0x01);
+
+       return ret;
+}
+
+static bool board_ksz_init(void)
+{
+       static bool switch_is_alive = false;
 
        if (!switch_is_alive) {
-               struct spi_slave *slave = spi_setup_slave(0, 1, 5000000, SPI_MODE_3);
+               struct spi_slave *slave = spi_setup_slave(0, 1, KSZ_MAX_HZ, SPI_MODE_3);
                if (slave) {
                        if (!spi_claim_bus(slave)) {
-                               unsigned char dout[3] = { 2, 1, 1, };
-                               unsigned char din[3];
-                               ret = spi_xfer(slave, sizeof(dout) * 8, dout, din, SPI_XFER_BEGIN | SPI_XFER_END);
-                               if (!ret)
-                                       switch_is_alive = true;
+                               bool phy_is_ksz = (ksz8893m_reg_read(slave, KSZ_REG_CHID) == 0x88);
+                               int ret = phy_is_ksz ? ksz8893m_reset(slave) : 0;
+                               switch_is_alive = (ret == 0);
                                spi_release_bus(slave);
                        }
                        spi_free_slave(slave);
                }
        }
 
-       if (switch_is_alive)
-               return bfin_EMAC_initialize(bis);
-       else
-               return -1;
+       return switch_is_alive;
+}
+
+int board_eth_init(bd_t *bis)
+{
+       if (KSZ_POSSIBLE) {
+               if (!board_ksz_init())
+                       return 0;
+       }
+       return bfin_EMAC_initialize(bis);
 }
 #endif
 
@@ -97,5 +151,27 @@ int misc_init_r(void)
                board_init_enetaddr(enetaddr);
 #endif
 
+#ifndef CONFIG_SYS_NO_FLASH
+       /* we use the last sector for the MAC address / POST LDR */
+       extern flash_info_t flash_info[];
+       flash_protect(FLAG_PROTECT_SET, 0x203F0000, 0x203FFFFF, &flash_info[0]);
+#endif
+
        return 0;
 }
+
+int board_early_init_f(void)
+{
+       /* connect async banks by default */
+       const unsigned short pins[] = {
+               P_AMS2, P_AMS3, 0,
+       };
+       return peripheral_request_list(pins, "async");
+}
+
+#ifdef CONFIG_BFIN_SDH
+int board_mmc_init(bd_t *bis)
+{
+       return bfin_mmc_init(bis);
+}
+#endif