#include <config.h>
#include <common.h>
-#include <asm/sizes.h>
+#include <linux/sizes.h>
#include <asm/io.h>
+#include <asm/gpio.h>
#include <asm/arch/hardware.h>
#include <asm/arch/clk.h>
#include <asm/arch/at91_matrix.h>
#include <asm/arch/at91sam9_smc.h>
#include <asm/arch/at91_pmc.h>
#include <asm/arch/at91_pio.h>
-#include <asm/arch/at91_rstc.h>
#include <asm/arch/at91sam9263.h>
#include <asm/arch/gpio.h>
#include <asm/arch/at91_common.h>
/* Configure RDY/BSY */
#ifdef CONFIG_SYS_NAND_READY_PIN
- at91_set_pio_input(CONFIG_SYS_NAND_READY_PIN, 1);
+ gpio_direction_input(CONFIG_SYS_NAND_READY_PIN);
#endif
/* Enable NandFlash */
- at91_set_pio_output(CONFIG_SYS_NAND_ENABLE_PIN, 1);
+ gpio_direction_output(CONFIG_SYS_NAND_ENABLE_PIN, 1);
}
#endif
#ifdef CONFIG_MACB
static void vl_ma2sc_macb_hw_init(void)
{
- unsigned long erstl;
at91_pmc_t *pmc = (at91_pmc_t *) ATMEL_BASE_PMC;
- at91_rstc_t *rstc = (at91_rstc_t *) ATMEL_BASE_RSTC;
+
/* Enable clock */
writel(1 << ATMEL_ID_EMAC, &pmc->pcer);
- erstl = readl(&rstc->mr) & AT91_RSTC_MR_ERSTL_MASK;
-
- /* Need to reset PHY -> 500ms reset */
- writel(AT91_RSTC_KEY | AT91_RSTC_MR_ERSTL(0x0D) |
- AT91_RSTC_MR_URSTEN, &rstc->mr);
-
- writel(AT91_RSTC_KEY | AT91_RSTC_CR_EXTRST, &rstc->cr);
- /* Wait for end hardware reset */
- while (!(readl(&rstc->sr) & AT91_RSTC_SR_NRSTL))
- ;
-
- /* Restore NRST value */
- writel(AT91_RSTC_KEY | erstl | AT91_RSTC_MR_URSTEN, &rstc->mr);
+ at91_phy_reset();
at91_macb_hw_init();
}
return rc;
}
-#ifdef CONFIG_SOFT_I2C
+#ifdef CONFIG_SYS_I2C_SOFT
void i2c_init_board(void)
{
u32 pin;