select DRA7XX
select TI_I2C_BOARD_DETECT
select PHYS_64BIT
+ imply SCSI
+ imply DM_PMIC
+ imply PMIC_LP87565
+ imply DM_REGULATOR
+ imply DM_REGULATOR_LP87565
config TARGET_AM57XX_EVM
bool "AM57XX"
select BOARD_LATE_INIT
select DRA7XX
select TI_I2C_BOARD_DETECT
+ imply SCSI
endchoice
config SYS_SOC
default "omap5"
-config TI_SECURE_EMIF_REGION_START
- hex "Reserved EMIF region start address"
- depends on TI_SECURE_DEVICE
- default 0x0
+config OMAP_PLATFORM_RESET_TIME_MAX_USEC
+ int "Something"
+ range 0 31219
+ default 31219
help
- Reserved EMIF region start address. Set to "0" to auto-select
- to be at the end of the external memory region.
-
-config TI_SECURE_EMIF_TOTAL_REGION_SIZE
- hex "Reserved EMIF region size"
- depends on TI_SECURE_DEVICE
- default 0x0
- help
- Total reserved EMIF region size. Default is 0, which means no reserved EMIF
- region on secure devices.
-
-config TI_SECURE_EMIF_PROTECTED_REGION_SIZE
- hex "Size of protected region within reserved EMIF region"
- depends on TI_SECURE_DEVICE
- default 0x0
- help
- This config option is used to specify the size of the portion of the total
- reserved EMIF region set aside for secure OS needs that will be protected
- using hardware memory firewalls. This value must be smaller than the
- TI_SECURE_EMIF_TOTAL_REGION_SIZE value.
+ Most OMAPs' provide a way to specify the time for which the reset
+ should be held low while the voltages and Oscillator outputs
+ stabilize.
+ This time is mostly board and PMIC dependent. Hence the boards are
+ expected to specify a pre-computed time using the above option.
+ This value can be computed using a summation of the below 3
+ parameters
+ 1: Time taken by the Osciallator to stop and restart
+ 2: PMIC OTP time
+ 3: Voltage ramp time, which can be derived using the PMIC slew rate
+ and value of voltage ramp needed.
if TARGET_DRA7XX_EVM || TARGET_AM57XX_EVM
menu "Voltage Domain OPP selections"