compatible = "pine64,pine-h64", "allwinner,sun50i-h6";
aliases {
+ ethernet0 = &emac;
serial0 = &uart0;
};
stdout-path = "serial0:115200n8";
};
+ connector {
+ compatible = "hdmi-connector";
+ type = "a";
+
+ port {
+ hdmi_con_in: endpoint {
+ remote-endpoint = <&hdmi_out_con>;
+ };
+ };
+ };
+
leds {
compatible = "gpio-leds";
gpios = <&r_pio 0 7 GPIO_ACTIVE_HIGH>; /* PL7 */
};
};
+
+ reg_usb_vbus: vbus {
+ compatible = "regulator-fixed";
+ regulator-name = "usb-vbus";
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ startup-delay-us = <100000>;
+ gpio = <&r_pio 0 5 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ };
};
-&mmc0 {
+&emac {
pinctrl-names = "default";
- pinctrl-0 = <&mmc0_pins>;
+ pinctrl-0 = <&ext_rgmii_pins>;
+ phy-mode = "rgmii";
+ phy-handle = <&ext_rgmii_phy>;
+ phy-supply = <®_aldo2>;
+ allwinner,rx-delay-ps = <200>;
+ allwinner,tx-delay-ps = <200>;
+ status = "okay";
+};
+
+&mdio {
+ ext_rgmii_phy: ethernet-phy@1 {
+ compatible = "ethernet-phy-ieee802.3-c22";
+ reg = <1>;
+ };
+};
+
+&de {
+ status = "okay";
+};
+
+&hdmi {
+ status = "okay";
+};
+
+&hdmi_out {
+ hdmi_out_con: endpoint {
+ remote-endpoint = <&hdmi_con_in>;
+ };
+};
+
+&ehci0 {
+ status = "okay";
+};
+
+&ehci3 {
+ status = "okay";
+};
+
+&mmc0 {
vmmc-supply = <®_cldo1>;
cd-gpios = <&pio 5 6 GPIO_ACTIVE_LOW>;
+ bus-width = <4>;
status = "okay";
};
&mmc2 {
- pinctrl-names = "default";
- pinctrl-0 = <&mmc2_pins>;
vmmc-supply = <®_cldo1>;
vqmmc-supply = <®_bldo2>;
non-removable;
cap-mmc-hw-reset;
+ bus-width = <8>;
+ status = "okay";
+};
+
+&ohci0 {
+ status = "okay";
+};
+
+&ohci3 {
status = "okay";
};
+&pio {
+ vcc-pc-supply = <®_bldo2>;
+ vcc-pd-supply = <®_cldo1>;
+ vcc-pg-supply = <®_aldo1>;
+};
+
&r_i2c {
status = "okay";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
regulator-name = "vcc-ac200";
+ regulator-enable-ramp-delay = <100000>;
};
reg_aldo3: aldo3 {
pcf8563: rtc@51 {
compatible = "nxp,pcf8563";
reg = <0x51>;
+ interrupt-parent = <&r_intc>;
+ interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
#clock-cells = <0>;
};
};
+&r_pio {
+ vcc-pm-supply = <®_aldo1>;
+};
+
&uart0 {
pinctrl-names = "default";
pinctrl-0 = <&uart0_ph_pins>;
status = "okay";
};
+
+&usb2otg {
+ dr_mode = "host";
+ status = "okay";
+};
+
+&usb2phy {
+ usb0_vbus-supply = <®_usb_vbus>;
+ usb3_vbus-supply = <®_usb_vbus>;
+ status = "okay";
+};